Abstract:Fabrication and organosilane-functionalization and characterization of nanostructured ITO electrodes are reported. Nanostructured ITO electrodes were obtained by electron beam evaporation, and a subsequent annealing treatment was selectively performed to modify their crystalline state. An increase in geometrical surface area in comparison with thin-film electrodes area was observed by atomic force microscopy, implying higher electroactive surface area for nanostructured ITO electrodes and thus higher detection levels. To investigate the increase in detectability, chemical organosilane-functionalization of nanostructured ITO electrodes was performed. The formation of 3-glycidoxypropyltrimethoxysilane (GOPTS) layers was detected by X-ray photoelectron spectroscopy. As an indirect method to confirm the presence of organosilane molecules on the ITO substrates, cyclic voltammetry and electrochemical impedance spectroscopy (EIS) were also carried out. Cyclic voltammograms of functionalized ITO electrodes presented lower reduction-oxidation peak currents compared with non-functionalized ITO electrodes. These results demonstrate the presence of the epoxysilane coating on the ITO surface. EIS showed that organosilane-functionalized electrodes present higher polarization resistance, acting as an electronic barrier for the electron transfer between the conductive solution and the ITO electrode. The results of these electrochemical measurements, together with the significant difference in the X-ray spectra between bare ITO and organosilane-functionalized ITO substrates, may point to a new exploitable oxide-based nanostructured material for biosensing applications. As a first step towards sensing, rapid functionalization of such substrates and their application to electrochemical analysis is tested in this work. Interestingly, oxide-based materials are highly integrable with the silicon chip technology, which would permit the easy adaptation of such sensors into lab-on-a-chip configurations, providing benefits such as reduced size and weight to facilitate on-chip integration, and leading to low-cost mass production of microanalysis systems.

Aminosilanized Interface Promotes Electrochemically Stable Carbon Nitride Films with Fewer Trap States on FTO for (Photo)electrochemical Systems

Fast Assembly of Si-CNFs Anodes for High-Performance Lithium-Ion Batteries

Constructing porous intramolecular donor-acceptor integrated carbon nitride doped with <i>m</i>-aminophenol for boosting photocatalytic degradation and hydrogen evolution activity

Interface engineering of Z-scheme α-Fe2O3/g-C3N4 photoanode: Simultaneous enhancement of charge separation and hole transportation for photoelectrocatalytic organic pollutant degradation

Surface Engineering of Carbon Nitride Electrode by Molecular Cobalt Species and Their Photoelectrochemical Application

Selective Nitrate Electroreduction to Ammonia on CNT Electrodes with Controllable Interfacial Wettability

Aminosilanization Nanoadhesive Layer for Nanoelectric Circuits with Porous Ultralow Dielectric Film

Revealing the interface-rectifying functions of a Li-cyanonaphthalene prelithiation system for SiO electrode

Diazonium-Functionalized Silicon Hybrid Photoelectrodes: Film Thickness and Composition Effects on Photoelectrochemical Behavior

Prelithiation-coupled defluorination polymerization for constructing LiF-rich oligomers interface for highly stable SiO anode

Interfacial engineering-induced electronic regulation drastically enhances the electrocatalytic oxygen evolution: Immobilization of Janus-structured NiS/NiO nanoparticles onto carbon nanotubes/nanofiber-integrated superstructures

Electrochemical Preparation and Characterization of Surface-Fluorinated TiO2 Nanoporous Film and Its Enhanced Photoelectrochemical and Photocatalytic Properties

Porous carbon nitride rods as an efficient photoanode for water splitting and benzylamine oxidation

Enhanced Photocatalytic CO2 Reduction by Amine Functionalization of Graphitic Carbon Nitride

Tunable surface-enhanced infrared absorption on au nanofilms on si fabricated by self-assembly and growth of colloidal particles.

Understanding the in-situ transformation of CuxO interlayers to increase the water splitting efficiency in NiO/n-Si photoanodes

Organosilane-functionalization of nanostructured indium tin oxide films

Alkylthiol Surface Engineering: An Effective Strategy Toward Enhanced Electrocatalytic N-2-To-Nh3 Fixation By A Cop Nanoarray

High-efficiency C3 Electrosynthesis on a Lattice-Strain-stabilized Nitrogen-Doped Cu Surface

Atomic/Molecular Layer-Deposited Laminated Li 2 O-Lithicone Interfaces Enabling High-Performance Silicon Anodes

Directly Anchoring Fe3C Nanoclusters and FeNx Sites in Ordered Mesoporous Nitrogen-Doped Graphitic Carbons to Boost Electrocatalytic Oxygen Reduction