Abstract:Two-dimensional (2D) metal halide perovskites have recently emerged as promising photovoltaic materials due to their superior ambient stability and rich structural diversity. However, power conversion efficiencies (PCEs) of the 2D perovskites solar cells (PSCs) still lag behind their three-dimensional (3D) counterpart, particularly due to the anisotropy in the charge carrier mobility and inhomogeneous energy landscape. A promising alternative is Dion-Jacobson (D-J) phase quasi-2D perovskite, where the bulky organic diammonium cations are introduced into inorganic frameworks to remove the weak van der Waals interactions between interlayers and to improve the open-circuit voltage (Voc). Although the D-J phase 2D perovskite shows a homogeneous energy landscape and better charge transport, their poor crystallinity and existence of higher trap states remain a major challenge for the development of high-efficiency solar cells device. To address this issue, here, we report the eclipsed D-J phase 2D perovskite using 1,5-diaminonaphthalene cation and subsequently treated the film with ammonium thiocyanate (NH4SCN) additive to further improve the film crystallinity, out-of-plane orientation, and carrier mobility. We observe that 2 mol NH4SCN surface treatment in NDA-based D-J phase perovskite leads to better film morphology and improved crystallinity, as confirmed by X-ray diffraction (XRD) and scanning electron microscopy (SEM). Time-resolved photoluminescence (TRPL) spectroscopy and steady-state space charge limited current (SCLC) mobility measurement reveal a significant reduction of trap-assisted nonradiative recombination and improvement of carrier mobility in the thiocyanate-passivated perovskite. Consequently, the PCE of the NH4SCN-treated (NDA)(MA)3(Pb)4(I)13 perovskite device enhanced nearly 46% from 10.3 to 15.08%. We have further studied intensity-dependent J-V characteristics, which demonstrate the reduction of ideality factor, confirming the effective suppression of trap-assisted nonradiative recombination, consistent with the transient PL results. Electrochemical impedance spectroscopy (EIS) confirms the improved charge carrier transport in NH4SCN additive-treated devices. Interestingly, our additive-engineered unsealed perovskite devices retained 75% of their initial efficiency after 1000 h of continuous storage under 60% relative humidity. This study opens up the strategy for developing high-efficiency and stable 2D perovskite solar cells.

Highly Efficient and Stable Dion–Jacobson(DJ) 2D-3D Perovskite Solar Cells with 26% Conversion Efficiency: A SCAPS-1D Study

Achieving 31.16 % efficiency in perovskite solar cells via synergistic Dion-Jacobson 2D-3D layer design

Dion-Jacobson and Ruddlesden-Popper double-phase 2D perovskites for solar cells

Dion-Jacobson 2D-3D perovskite solar cells with improved efficiency and stability

Highly Efficient and Stable Dion−Jacobson Perovskite Solar Cells Enabled by Extended π‐Conjugation of Organic Spacer

2D Dion Jacobson/3D perovskite heterojunction solar cells without hole transport layer: Further optimize the performance by SCAPS-1D

Harnessing the potential of Dion-Jacobson perovskite solar cells: Insights from SCAPS simulation techniques

Compositional and Solvent Engineering in Dion–Jacobson 2D Perovskites Boosts Solar Cell Efficiency and Stability

Controlled Dion-Jacobson Low-Dimensional Surface Phase Enables Highly Efficient and Stable Perovskite Solar Cells

Leveraging Dion–Jacobson Interface Hierarchies for Defect Alleviation in High-Efficiency and Durable Perovskite Solar Cells

Two-dimensional Dion-Jacobson Halide Perovskites As New-Generation Light Absorbers for Perovskite Solar Cells

Highly Efficient 3D–2D Perovskite Tandem Solar Cells: A Combined Ray Tracing and Transfer Matrix-Based Simulation Study

High Efficiency Perovskite Solar Cells Employing Quasi‐2D Ruddlesden‐Popper/Dion‐Jacobson Heterojunctions

Cesium-doped Dion-Jacobson 2D perovskites for highly stable photovoltaics with an 18.3% efficiency

Ultrastable and efficient slight-interlayer-displacement 2D Dion-Jacobson perovskite solar cells

Multiple-Noncovalent-Interaction-Stabilized Layered Dion–Jacobson Perovskite for Efficient Solar Cells

Vertical Orientated Dion–Jacobson Quasi‐2D Perovskite Film with Improved Photovoltaic Performance and Stability

Dion-Jacobson Phase 2D Layered Perovskites for Solar Cells with Ultrahigh Stability

Thiocyanate-Passivated Diaminonaphthalene-Incorporated Dion-Jacobson Perovskite for Highly Efficient and Stable Solar Cells

Triple-junction Dion-Jacobson perovskite tandem solar cells: advancing efficiency via interface optimization and broadened light absorption spectrum

Enhancing the efficiency and stability of 2D-3D perovskite solar cells with embedded interface passivation with diammonium cation spacer