Abstract:The industrial torch system is used to handle large amounts of flammable, toxic, and corrosive gases emitted during accidents or normal production processes. It utilizes open flames to burn off the gas pollutants. This study employs computational fluid dynamics (CFD) to investigate the combustion characteristics and efficiency of flames under high-velocity jet, aiming to address the issue of low combustion efficiency under high-velocity jet conditions. A three-dimensional flame model was established using methane and air as fuel, in order to investigate the variations and impact mechanisms of the combustion flame temperature field and carbon dioxide mass fraction distribution under different jet velocities, pilot component temperatures, and equivalence ratios. The reasons for low combustion efficiency under high-velocity jet conditions were analyzed. It was proposed to increase the combustion efficiency of the flame by raising the temperature of the pilot component, which differs from the traditional method of adding combustion-assisting gases. The combustion efficiency of flames under various operating conditions was evaluated. The results showed that as the jet velocity ( v ) increased from 49.6 m/s to 65 m/s, the height of the combustion flame in the vertical direction decreased continuously. Additionally, the high-temperature region at the center of the flame gradually decreased, leading to a 5.26% decrease in the highest flame temperature and a 3% decrease in combustion efficiency. When v = 70 m/s, the high-velocity fuel flow penetrated the ignition source, causing a large amount of methane to escape into the atmosphere without combustion, resulting in flame extinction. Elevating the temperature ( T ) of the pilot component can reduce the impact of high-velocity jet on combustion efficiency. When T = 2000 K, the flame reignites with a combustion efficiency of 94.1%. As the mass flow rate of the fuel composition inlet is reduced from 33.45 × 10 −5 kg/s to 12.74 × 10 −5 kg/s, the highest temperature of the combustion flame drops from 2072 K to 1451 K. As the equivalence ratio ( φ ) increases from 1.05 to 1.2, the height of the combustion flame in the vertical direction decreases continuously, resulting in a 0.7% decrease in the highest flame temperature and a 10.5% decrease in combustion efficiency.

Flame Deflector Modification for Improved Combustion Efficiency in Domestic Gas Ovens

Optical and Numerical Investigations of Flame Propagation in a Heavy Duty Spark Ignited Natural Gas Engine

The impact of turbulence and combustion models on flames and emissions in a low swirl burner

Optimum swirl angle of natural gas combustion in domestic cooker burner with various output port

Fire Extinguishing Performance Evaluation of the Downward Water Mist to Methane-Air Premixed Laminar Flame

EFFECT OF THE GEOMETRICAL PARAMETERS IN A DOMESTIC BURNER WITH CRESCENT FLAME CHANNELS FOR AN OPTIMAL TEMPERATURE DISTRIBUTION AND THERMAL EFFICIENCY

Experimental and Numerical Simulation Research on Different Shapes of Flame-Stabilizing Baffles in the Furnace

Numerical experiment on complex characteristics of perimeter air deflectable deposited burner

Experimental Investigation of the Effect of the Burner Cap Geometry on the Performance of a Domestic Liquefied Petroleum Gas Stove

Efficiency study of low calorific value high momentum turbulent jet combustion flame

Effect of Burner Structure Characteristics on Flameless Combustion of Non-Preheated Gas

Study on the Flame Transition Characteristics of a Gas Turbine Combustor

The Structural Design of and Experimental Research on a Coke Oven Gas Burner

Computational Study of Deflagration-to-Detonation Transition in a Semi-Confined Slit Combustor

Low-Nox Modification of A Heavy Fuel Oil Swirl Burner Based on Semi-Industrial Scale Experimental Tests

Experimental and numerical study of the cooling characteristics of the double-walled cooling structure on integral support plate

Experimental study on the combustion characteristics of an asymmetric swirling flameless combustor using biogas

Numerical simulation of combustion distribution in a gas burner

A Novel Flame-Anchorage Micro-Combustor: Effects of Flame Holder Shape and Height on Premixed CH4/air Flame Blow-off Limit

Characteristic Visualization of the Micro/mesoscale Liquid Ethanol Diffusion Flame by Using Deflection Tomography

Flame investigations of a laboratory-scale CECOST swirl burner at atmospheric pressure conditions