Abstract:Since power systems with a DC distribution method has many advantages, such as conversion efficiency increase of about 5–10%, cost reducing by about 15–20% and so on, the AC distribution power system will be replaced by a DC distribution one. This paper presents a DC load power system for a DC distribution application. The proposed power system includes two converters: DC/DC converter with battery source and power factor corrector (PFC) with a line source to increase the reliability of the power system when renewable energy or energy storage equipment are adopted. The proposed PFC adopts a bridgeless flyback converter to achieve power factor correction for supplying power to DC loads. When the bridgeless flyback converter is used to achieve PFC, it needs two transformers to process positive and negative half periods, respectively. In order to increase conversion efficiency, the flyback one can add two sets of the active clamp circuit to recover energies stored in leakage inductances of transformers in the converter. Therefore, the proposed bridgeless flyback converter can not only integrate two transformers into a single transformer, but also share a clamp capacitor to achieve energy recovery of leakage inductances and to operate switches with zero-voltage switching (ZVS) at the turn-on transition. With this approach, the proposed converter can increase conversion efficiency and decrease component counts, where it results in a higher conversion efficiency, lower cost, easier design and so on. Finally, a prototype with a universal input voltage source (AC 90–265 V) under output voltage of 48 V and maximum output power of 300 W has been implemented to verify the feasibility of the proposed bridgeless flyback converter. Furthermore, the proposed power system can be operated at different cases among load power PL, output power PDC1 of DC/DC converter and output power PDC2 of the proposed PFC for supplying power to DC loads.

A Modified Asymmetrical Half-Bridge Flyback Converter for Step-Down AC–DC Applications

A high efficiency bridgeless flyback PFC converter for adapter application

A Step Up/Down Power-Factor-Correction Converter with Modified Dual Loop Control

Asymmetric Modulation of Bridgeless Single‐stage Full‐bridge AC–DC Converter for Active Power Factor Correction and Zero Voltage Switching

High Power Factor Bridgeless Integrated Buck-Type PFC Converter With Wide Output Voltage Range

Single-Stage Integrated Buck-Flyback PFC Converter With Low Total Harmonic Distortion Control

A Dual Half-Bridge Converter With Current Doubler Rectifier

High Step-Up/Down Switched-Capacitor Based Bidirectional DC-DC Converter

Power Factor Corrector with Bridgeless Flyback Converter for DC Loads Applications

Series Asymmetrical Half-Bridge Converters With Voltage Autobalance for High Input-Voltage Applications

Isolated Series-Capacitor-Based Full-Bridge Converter with Reduced Circulating Losses and Wide Soft Switching Range

Reconfigurable Half-Bridge Based on Dickson SC Converter for Wide Input Voltage Range Applications

New Single-Stage Single-Phase Isolated Bidirectional AC-DC PFC Converter

High Step-Up/Step-Down Soft-Switching Bidirectional Dc-Dc Converter With Coupled-Inductor And Voltage Matching Control For Energy Storage Systems

AC–DC Bridgeless Buck Converter with High PFC Performance by Inherently Reduced Dead Zones

Unified Algorithm of Single-Phase Active AC-DC Converters and Its Applications

An Isolated High-Frequency Dc-Ac Converter Based On Differential Structure With Ultralow Distortion Output Voltage

A Nonisolated High Step-Down DC–DC Converter With Low Voltage Stress and Zero Voltage Switching

A Dual-Transformer Based Hybrid Semi-Dual Active Bridge Converter for Wide Voltage Range Applications Utilizing Simple Segmented Control

A Compact Single-Phase Cascaded Three-Level AC/DC Converter With Variable DC Bus Voltage and Low CM Noise

High-Efficiency Hybrid Full-Bridge–Half-Bridge Converter with Shared ZVS Lagging Leg and Dual Outputs in Series