Abstract:To solve the problem of the control accuracy in electrohydraulic loading systems caused by load increment, this paper proposes a multi-cylinder electrohydraulic digital loading (MEDL) technology for accurate reproduction of large load. A traditionally used single cylinder loading (SCL) is replaced by a new hydraulic cylinders group that includes N hydraulic cylinders at each point, in which one is controlled by the electrohydraulic servo valve and the others (N-1) are controlled by the on-off valve. The areas of the on-off valve controlled (OVC) cylinders form an increasing geometric sequence with a common ratio of 2. In addition, the force of the servo valve controlled (SVC) cylinder can be regulated continuously, and the OVC cylinders have only two states of no force or maximum force. There should be no force tracking error caused by nonlinear factors for the OVC cylinders. Thus, a continuous accurate large loading can be achieved by changing the working area of the cylinders group. Moreover, an improved full closed-loop (FCL) control strategy is proposed to solve the load reverse sudden change caused by the asynchronous opening and closing of the servo valve and on-off valve. With a case of N = 4 for MEDL, AMESim simulation results illustrated that the tracking error of the 4-cylinder group was about 1/6 of the single cylinder under a case of 40 kN. Furthermore, extensive experiments conducted on a real full loading bench under the FCL control method indicated that compared with SCL, the tracking error of the 4-cylinder group with a multi-step signal and various-frequency sinusoidal signals were reduced by 73% and 46%, respectively. Both simulation and experimental results proved that the proposed MEDL technology improved the loading accuracy and optimized the dynamic performance of the system.

System for electrical compensation of luffing mechanism of gantry crane

Multi-actuated Mechanism Design Considering Structure Flexibility Using Correlated Performance Reinforcing

Rigid-flexible coupling dynamics and characteristics of marine excavator’s mechanical arm

Nonlinear Control for an Active-passive Hybrid Compensation System

Motion synchronization control of four multi-stage cylinders electro-hydraulic elevating system

Balanced Design Method for LCL/LCL Compensation Achieving Wide Load Range and High Misalignment Tolerance

State Constrained Variable Structure Control for Active Heave Compensators.

Rotation and Gate Movement Compound Control of Screw Conveyor Hydraulic System with Disturbance Compensation

Design and Simulation of a Hydraulic System for Jumbo Screw Conveyors Based on Flow Compensation

Electrohydraulic control system of opened TBM tunnel bottom slag removing device

Modeling and H∞ Position Control of a Spreader in the Gantry Crane

Crane and luffing mechanism thereof

Pump-Based Compensation for Dynamic Improvement of the Electrohydraulic Flow Matching System.

Valve-based compensation for controllability improvement of the energy-saving electrohydraulic flow matching system

Hierarchical Fuzzy-Tuned Multiobjective Optimization Control for Gantry Cranes

Robust control of gantry crane system with hoisting: A new solution based on wave motion

Decoupling Compensation for Damping Improvement of the Electrohydraulic Control System with Multiple Actuators

Research and Application of Portal Crane’s Luffing Mechanism Design Based on Modern Design Method

Multi-cylinder electrohydraulic digital loading technology for reproduction of large load

Design and Control of Hydraulic Hybrid System for Excavators

Adaptive Robust Control of Linear Electrical Loading System with Dynamic Friction Compensation