Abstract:High MR and low ozone emission can be obtained simultaneously in MS1 reactor.Catalyst packed in zone II can enhance MR by effectively utilizing edge discharge.MR and EY should be considered comprehensively to select operation conditions.Few amount of Ag/ZSM-5 packed in zone III could exhibit better O3 elimination.The reaction mechanism of multi-stage DBD-catalytic system was elucidated.DBD-catalytic system has been widely studied for volatile organic compounds abatement, whereas how to obtain high mineralization rate and low zone emission synchronously remains a challenge. In view of this, a new type of multi-stage DBD-catalytic system (MS1) was established to abatement toluene in this study. The mineralization rates of reactors IPC (63.81%) and MS1 (61.14%) were much higher than MS2, PPC1 and PPC2 reactors, which were 48.36%, 46.84%, and 5.8% at 33.8 (Vp-p) kV, respectively. For export ozone concentration, IPC reactor had the highest concentration of 160 ppm, and the values of reactors MS1, MS2, PPC1, and PPC2 were 79, 34.2, 34.25 and 29 ppm, respectively. The catalyst filled in zone II can be utilized to further decompose the residual toluene and intermediates and also promote the decomposition of ozone, which lead to the superior performance of the MS1 reactor. The influence of applied voltage, adsorbed amount, and discharge time on the toluene removal performance was investigated to optimize the operation parameters of MS1 reactor, their appropriate values were 28.3-31.1 (Vp-p) kV, 0.179-0.223 mmol, ∼1h, respectively. Lastly, the contribution of disparate zones in multi-stage DBD-catalytic system to the toluene degradation were elucidated on the basis of the GC-MS results.Download : Download high-res image (82KB)Download : Download full-size image

Removal of toluene using an integrative DBD/Absorption reactor: feasibility and mechanism

Removal of Dilute VOCs in Air by Post-Plasma Catalysis over Ag-based Composite Oxide Catalysts

A Comparison Study of Toluene Removal by Two-Stage DBD-catalyst Systems Loading with MnO X , CeMnO X , and CoMnO X

A novel double dielectric barrier discharge reactor for toluene abatement: Role of different discharge zones and reactive species

High energy efficient degradation of toluene using a novel double dielectric barrier discharge reactor

Dielectric Barrier Discharge Coupled with Fe2+, Mn2+ and Cu2+ Scrubbing for Toluene Removal.

Abatement of toluene from gas streams via ferro-electric packed bed dielectric barrier discharge plasma

Abatement of Toluene from Gas Streams by Using Dielectric Barrier Discharge

Combined dielectric barrier discharge and water absorption for decomposition of VOCs

Abatement of Toluene by Reverse-Flow Nonthermal Plasma Reactor Coupled with Catalyst

Impact of the geometric structure parameter on the performance of dielectric barrier reactor for toluene removal

Study on Abatement of Toluene by Alterable Frequency Dielectric Barrier Discharge

Experimental study on removal of toluene by alterable frequency dielectric barrier discharge

Toluene removal characteristics by a superimposed wire-plate dielectric barrier discharge plasma reactor

Decomposition of toluene by dielectric barrier discharge comnbined with catalytic ozonation

Experimental Studies of Removing Typical VOCs by Dielectric Barrier Discharge Reactor of Different Sizes

A highly efficient multi-stage dielectric barrier discharge (DBD)-catalytic system for simultaneous toluene degradation and O3 elimination

Design of a novel DBD reactor for simultaneous decomposition of exhaust gas and wastewater

Efficient Activation of the Co/SBA-15 Catalyst by High-Frequency AC-DBD Plasma Thermal Effects for Toluene Removal

Volatile Organic Compounds (VOCs) Removal by Using Dielectric Barrier Discharge

Double dielectric barrier discharge incorporated with CeO2-Co3O4/γ-Al2O3 catalyst for toluene abatement by a sequential adsorption–discharge plasma catalytic process