Abstract:Current research has shown a nonlinear trend in the failure of soil, and the single tangent method is commonly adopted when coping with nonlinear problems of soil failure. However, the method equates a nonlinear criterion to an optimizable linear criterion, which may differ from the actual situation, resulting in conservative results. In this paper, two types of piece-wise log-spiral failure mechanisms for bearing capacity estimations, including symmetrical and unilateral mechanisms were proposed with the nonlinear Mohr-Coulomb criterion. The static bearing capacity of foundations was evaluated using the symmetric failure mechanism, while the seismic bearing capacity of foundations was evaluated adopting a modified pseudo-dynamic method based on the unilateral failure mechanism. The result shows that the bearing capacity calculated in the paper is smaller compared to the result using the linear Mohr-Coulomb criterion. For London clay, the static bearing capacity is reduced by about 45% at a foundation width equal to 1m. From the comparisons, it is found that the proposed approach of piece-wise log-spiral failure mechanism for bearing capacity estimation is effective. In addition, parametric studies show that the nonlinear parameters, the initial factor of seismic acceleration, the normalized frequency, and the damping ratio all have obvious effects on the seismic bearing capacity. A significant reduction in the seismic bearing capacity of the foundation occurs when the normalized frequency ω s H / V s is equal to (0.5 + n ) π ( n = 0, 1, 2, ...). Considering that the approach proposed provides a strict upper bound to the bearing capacity, the result imparts confidence in the approach of analysis presented.

Method of Rigorous Characteristics for Seismic Bearing Capacity of Strip Footings Placed Adjacent to Homogeneous Soil Slopes

Oblique and eccentric bearing capacity of embedded strip footings using the method of rigorous characteristics

Seismic Bearing Capacity of Strip Footings with Modified Pseudo-dynamic Method

The Bearing Capacity Factor Nγ of Strip Footings on C–ϕ–γ Soil Using the Method of Characteristics

Seismic bearing capacity of strip footings placed on reinforced soil slopes using slip line method

Rocking Vibration of a Rigid Strip Footing on Saturated Soil

Solution and error evaluation for bearing capacity of rough strip footings

Vertical Vibration of an Elastic Strip Footing on Saturated Soil

Semi-empirical Solution on Bearing Capacity of Strip Footing Considering Unit Weight of Soil

Stochastic Bearing Capacity and Failure Mechanism of Footings Placed Adjacent to Slopes considering the Anisotropic Spatial Variability of the Clay Undrained Strength

Probabilistic Assessment of Seismic Stability of a Rock Slope by Combining the Simulation of Stochastic Ground Motion with Permanent Displacement Analysis

Modified pseudo–dynamic bearing capacity of strip footing on rock masses

Ultimate bearing capacity of strip footings on Hoek-Brown rock slopes – A stress characteristics solution

Field Tests and Simplified Calculation Method for Static Drill Rooted Nodular Pile

Kinematic bearing capacity analysis of strip footings on reinforced soils using discretisation technique

Quantitative bearing capacity assessment of strip footings adjacent to two-layered slopes considering spatial soil variability

Rupture sismique des fondations par perte de capacité portante: Le cas des semelles circulaires

Seismic stability and failure mode of the slope containing a two-pile foundation

Stability of slopes in partially saturated soils: Incorporating the combined effects of seismic forces and pore water pressure

Analytical assessment of dynamic stability in 2D unsaturated soil slopes reinforced with piles

Modeling Strip Footings on Slopes Using the Material Point Method