Theoretical study on resonance frequencies of the vibration modes of Janus–Helmholtz transducer

Zhang Yishuang,Sang Yongjie,Chen Yongyao,Wu Shuai,,,,

DOI: https://doi.org/10.7498/aps.73.20231251

IF: 0.906

2024-01-01

Acta Physica Sinica

Abstract:Janus-Helmholtz transducer has the characteristics of high-power and broadband transmission due to the coupling between the longitudinal resonance of the driver and the liquid cavity resonance of Helmholtz resonator. Traditional view holds that the low frequency resonance on transmitting voltage response curve in water is fluid cavity mode of Helmholtz resonator while the high frequency resonance is the longitudinal mode of Janus transducer. However, considerable experimental studies have found the conclusion is in doubt in the past few decades. The purpose of this paper is to distinguish the correspondence between the two resonances on the response curve and the two vibration modes of Janus-Helmholtz transducer. Based on the Janus-Helmholtz transducer prototype reported in the literature, theoretical study on resonance frequencies of the vibration modes of Janus-Helmholtz transducer is carried out. The structure dimensions and material parameters of the prototype are listed in detail. Test and simulation results of conductivity are also presented in this paper. The longitudinal resonance of the driver was determined using equivalent circuit method and finite element analysis. Radiation masses of both Janus transducer and typical longitudinal vibration transducer are also calculated to analyze the phenomenon of the sharp decrease of longitudinal resonance frequency in water. Acoustic modal analysis by means of ANSYS software is used to investigate the resonance frequency of complex Helmholtz resonator in Janus-Helmholtz transducer. Correction length on the vent introduced by external fluid sound radiation is used to accurate Helmholtz resonance frequency. The sound pressure distribution of Helmholtz resonator obtained through finite element method is investigated, from which correct equivalent for solving the Helmholtz resonance frequency is concluded. Results reveal that the first resonance on response curve is driver resonance while the second one is Helmholtz resonance, which is contrary to the traditional view. The considerable reduction in driver resonance frequency in water is mainly due to the large radiation mass on the four large radiation surfaces of the Janus transducer, which also causes the sharp response of driver resonance. Two Helmholtz resonators with the same size are present in Janus-Helmholtz transducer instead of the traditional view that only one resonator exists. The two resonance frequencies solved by the method proposed in this paper are in good agreement with the test and simulation results. These conclusions play an important role in correctly understanding the structure and characteristics of Janus-Helmholtz transducer at source, as well as provide technical support for structural optimization and innovation, thus improving the acoustic emission properties of the transducer.

physics, multidisciplinary