Abstract:Bridges crossing active faults are more likely to suffer serious damage or even collapse due to the wreck capabilities of near-fault pulses and surface ruptures under earthquakes. Taking a high-speed railway simply-supported girder bridge with eight spans crossing an active strike-slip fault as the research object, a refined coupling dynamic model of the high-speed train-CRTS III slab ballastless track-bridge system was established based on ABAQUS. The rationality of the established model was thoroughly discussed. The horizontal ground motions in a fault rupture zone were simulated and transient dynamic analyses of the high-speed train-track-bridge coupling system under 3-dimensional seismic excitations were subsequently performed. The safe running speed limits of a high-speed train under different earthquake levels (frequent occurrence, design and rare occurrence) were assessed based on wheel-rail dynamic (lateral wheel-rail force, derailment coefficient and wheel-load reduction rate) and rail deformation (rail dislocation, parallel turning angle and turning angle) indicators. Parameter optimization was then investigated in terms of the rail fastener stiffness and isolation layer friction coefficient. Results of the wheel-rail dynamic indicators demonstrate the safe running speed limits for the high-speed train to be approximately 200 km/h and 80 km/h under frequent and design earthquakes, while the train is unable to run safely under rare earthquakes. In addition, the rail deformations under frequent, design and rare earthquakes meet the safe running requirements of the high-speed train for the speeds of 250, 100 and 50 km/h, respectively. The speed limits determined for the wheel-rail dynamic indicators are lower due to the complex coupling effect of the train-track-bridge system under track irregularity. The running safety of the train was improved by increasing the fastener stiffness and isolation layer friction coefficient. At the rail fastener lateral stiffness of 60 kN/mm and isolation layer friction coefficients of 0.9 and 0.8, respectively, the safe running speed limits of the high-speed train increased to 250 km/h and 100 km/h under frequent and design earthquakes, respectively.

Various Near-Fault Ground Motions for Seismic Analysis of High-Speed Railway Track Bridges

Seismic Response of Isolated Railway Bridge Subjected to Near-fault Ground Motion

Improvement of Stochastic Green's Function Method for 3D Broadband Ground-Motion Simulation

Applicability analysis of high-speed railway system under the action of near-fault ground motion

Refined Probabilistic Seismic Demand Modeling of High-Speed Railway Bridge Under Near-Fault Hanging-Wall Effects and Velocity Pulse Effects by a Novel Ground Motion Selection Approach

Study on the dynamic response correction factor of a coupled high-speed train–track–bridge system under near-fault earthquakes

Exceeding Probability of Earthquake-Induced Dynamic Displacement of Rail Based on Incremental Dynamic Analysis

Influence of velocity pulse effect on earthquake-induced track irregularities of high-speed railway track–bridge system under near-fault ground motions

Velocity pulse effects of near-fault earthquakes on a high-speed railway vehicle-ballastless track-benchmark bridge system

A Theoretical Investigation on Characteristic Frequencies of Ground Vibrations Induced by Elevated High Speed Train

Railway Alignment Optimization and Seismic Responses of High-Speed Railway Bridge Considering the Spatial Effects of Mountainous-Plateau

Simulation of Near-Fault Pulse-Like Ground Motion and Investigation of Seismic Response Characteristics in Subway Stations

Study on the estimate for seismic response of high-speed railway bridge-track system

Simplified and rapid prediction of earthquake-induced track dynamic irregularity of high-speed railway bridges under different site conditions

Effect of Ground Motion Time–Frequency Non-Stationarity on Seismic Response of High-Speed Railway Simply Supported Bridge Based on Wavelet Packet Transform

Dynamic Performance of Vehicle–Guideway Bridge Systems for Low–Medium-Speed Maglev Trains under Earthquakes

A physics‐based spectral matching (PBSM) method for generating fully site‐related ground motions

Seismic applicability analysis of high-speed railway multi-span simply-supported bridges based on simplified model

Nonlinear seismic response analysis of long-span railway cable-stayed bridges crossing strike-slip faults

Running safety assessment of a train traversing a three-tower cable-stayed bridge under spatially varying ground motion

Running safety and seismic optimization of a fault-crossing simply-supported girder bridge for high-speed railways based on a train-track-bridge coupling system