Structure regulation induced by adding bismuth nitrate in the MIL-101(Fe) preparation and its effects on adsorption-photocatalytic performance for micro-organic contaminants

Baichao Zhang,Jiejing Zhang,Lei Li,Yu Zhang,Qi Zuo,Hong Zheng

DOI: https://doi.org/10.1016/j.micromeso.2023.112853

IF: 5.876

2023-10-18

Microporous and Mesoporous Materials

Abstract:Herein, Bi(NO 3 ) 3 was innovatively introduced into the preparation process of MIL-101 (Fe), and the induced structural regulation and its impact on the adsorption-photocatalytic performance for micro-organic contaminants (MCs) were investigated systematically. The results show that, when FeCl 3 was used as an iron source and Bi(NO 3 ) 3 mole percentage reached 45 %, BiOCl/MIL-88B(Fe) composite heterojunction was formed in situ, showing high adsorption (49.5 %) and removal rate (81.8 % and 91.2 %) after 180 min under visible light and UV irradiation for low concentration tetracycline (TC), respectively. The organics adsorbed on the composite surface could be further decomposed. When Fe(NO 3 ) 3 was used as the iron source, the introduction of a small amount of Bi(NO 3 ) 3 (5 %) contributed to the preparation of MIL-88B(Fe/Bi) in situ and the generation of more surface hydroxyl groups. The adsorption and removal rate of TC under visible light reached 68.9 % and 90.8 %, respectively and the generated by-products were also effectively degraded. The in-situ prepared BiOCl/MIL-88B(Fe) heterojunction could effectively promote the separation of photogenerated carriers and the dark generated ·OH and ·O 2− could effectively accelerate the adsorption of pollutants. These results have opened up new ideas for the development of novel porous adsorption-photocatalysis materials with a simple preparation process, high efficiency, low cost, and the ability to effectively overcome the mass transfer resistance of MCs.

materials science, multidisciplinary,chemistry, physical,nanoscience & nanotechnology, applied