Abstract:Solid concentration and particle velocity distributions in the transition section of a ϕ 200mm turbulent fluidized bed (TFB) and a ϕ 200mm annulus turbulent fluidized bed (A-TFB) with a ϕ 50mm central standpipe were measured using a PV6D optical probe. It is concluded that in turbulent regime, the axial distribution of solid concentration in A-TFB was similar to that in TFB, but the former had a shorter transition section. The axial solid concentration distribution, probability density, and power spectral distributions revealed that the standpipe hindered the turbulence of gas–solid two-phase flow at a low superficial gas velocity. Consequently, the bottom flow of A-TFB approached the bubbling fluidization pattern. By contrast, the standpipe facilitated the turbulence at a high superficial gas velocity, thus making the bottom flow of A-TFB approach the fast fluidization pattern. Both the particle velocity and solid concentration distribution presented a unimodal distribution in A-TFB and TFB. However, the standpipe at a high gas velocity and in the transition or dilute phase section significantly affected the radial distribution of flow parameters, presenting a bimodal distribution with particle concentration higher near the internal and external walls and in downward flow. Conversely, particle concentration in the middle annulus area was lower, and particles flowed upward. This result indicated that the standpipe destroyed the core-annular structure of TFB in the transition and dilute phase sections at a high gas velocity and also improved the particle distribution of TFB. In conclusion, the standpipe improved the fluidization quality and flow homogeneity at high gas velocity and in the transition or dilute phase section, but caused opposite phenomena at low gas velocity and in the dense-phase section.

Dust distribution of solid and adhesive mixed dust in a granular bed filter

Experimental and numerical investigation of solid behavior in a gas–solid turbulent fluidized bed

CFD Simulation of an Agitated Gas-Fluidized Bed: Effects of Particle–particle Restitution Coefficient on the Hydrodynamics

Solid Concentration and Velocity Distributions in an Annulus Turbulent Fluidized Bed

Experimental study on filtering mixed solid–liquid dust with a sliding granular bed filter

CFD Simulation and Experiments of Dynamic Parameters in Gas–solid Fluidized Bed

Particle size distribution in a granular bed filter

Multi-scale Characteristics and Gas-Solid Interaction among Multiple Beds in a Dual Circulating Fluidized Bed Reactor System

Filtration characteristics of granular bed with layered drawers for removing dust from gas streams

Numerical simulation of a multilayer granular bed filter: Effect of bed structure on the filtration characteristics of high-temperature particulate matter

Experimental study on filtration characteristics of a novel moving granular bed filter

DEM/CFD Modelling of the Deposition of Dilute Granular Systems in a Vertical Container

Numerical study on filtration characteristics of high-temperature particulate matter in a three-dimensional randomly arranged multi-granularity particle bed filter

Filtration performance of the granular bed filter used for industrial flue gas purification: A review of simulation and experiment

Effect of filter granules properties on flow behavior in a moving granular filter

Experimental Research on the Gas-Solid Flow Characteristics in Large-Scale Dual Fluidized Bed Reactor

Heat Transfer Characteristics of High-Temperature Dusty Flue Gas from Industrial Furnaces in a Granular Bed with Buried Tubes

Filtration of dust particulates with a granular bed filter in a novel coupled separator

Size segregation of binary particles in a moving granular bed filter for hot gas clean-up

Filtration characteristics of a binary multi-layer granular bed filter based on CFD-DEM coupling simulation

Numerical investigation of flow stratification behavior of binary particle mixture for high-temperature flue gas filtration on an inclined moving bed