Ti 3 C 2 T x MXene/Bamboo Fiber/PDMS Pressure Sensor with Simultaneous Ultrawide Linear Sensing Range, Superb Environmental Stability, and Excellent Biocompatibility
Wei-Bin Zhu,Hong-Shan Luo,Zhen-Hua Tang,Hao Zhang,Ting Fan,You-Yong Wang,Pei Huang,Yuan-Qing Li,Shao-Yun Fu
DOI: https://doi.org/10.1021/acssuschemeng.1c07994
2022-03-08
Abstract:Ti3C2Tx MXene has drawn remarkable attention in electronic sensors. Existing MXene-based pressure sensors generally have a narrow linear sensing range, which limits their wide application. Moreover, previous studies on MXene-based pressure sensors were mainly focused on increasing sensitivity via various microengineering techniques, but little attention has been paid to environmental stability and biocompatibility of these sensors. Herein, a highly flexible, biocompatible, and environmentally stable Ti3C2Tx MXene/bamboo cellulose fiber (BCF)/poly(dimethylsiloxane) (PDMS) composite pressure sensor with an ultrawide working range (up to 2 MPa), a high linearity (R2 = 0.966), and long-term stability is demonstrated. First, the MXene/BCF (MB) foam with well-optimized porosity and connectivity was prepared through an efficient freeze-drying method. Then, the MB-based piezoresistive composite (PMB) was obtained by directly embedding the MB foams into PDMS elastomers. In striking contrast to previous MXene composite-based pressure sensors, the PMB pressure sensor exhibits not only excellent pressure sensing performance and good biocompatibility but also prominent work reliability to resist temperature fluctuation, moisture/water, and UV irradiation. Furthermore, to demonstrate the potential of the PMB pressure sensor, various human movements under both ambient and harsh environmental conditions were monitored. Finally, the PMB pressure sensor was also successfully integrated with soft robotic hands to show its great potential in robotic tactile sensation.The Supporting Information is available free of charge at https://pubs.acs.org/doi/10.1021/acssuschemeng.1c07994.SEM image of Ti3AlC2 particles (Figure S1); SEM images of the MB foams with 20, 40, and 50 wt % MXene nanosheets (Figure S2); typical compressive stress–strain curves of the MB foam, neat PDMS, and the PMB composite; compressive stress–strain curves of the PMB composite under varied applied strains from 5 to 80%, cyclic compressive stress–strain curves of the PMB composite during 1000 loading–unloading cycles with the peak strain of 15%; electrical resistivity of MB and PMB foam with 30 wt % MXene sheets (Figure S3); schematic illustration of the piezoresistive mechanism of the PMB sensor and cyclic RCR response with various pressure levels from 10 to 2000 kPa (Figure S4); contact angles of MB foam, PDMS, and PMB (Figure S5); RCR responses of the sensor for detecting knee flexion, elbow flexion, blowing, and bulging movements (Figure S6); and comparison of the PMB pressure sensor with the pressure sensors reported in the literature (Table S1) (PDF)This article has not yet been cited by other publications.
chemistry, multidisciplinary,engineering, chemical,green & sustainable science & technology