Abstract:Nanotubes are the most important structural elements of nanomaterials used in nanotechnological applications and are also used in the production of nanocomposite materials. In the reinforcement (in the fibers) of the structure of composite materials, the initial curvature occurring due to structural reasons or technological processes causes the appearance of self-balancing stresses. The magnitudes of these stresses can lead to exceeding of the safety limits of the material. Therefore, theoretical investigation of the mechanical behaviors of the material, under tension and compression in the direction of the strengthening (fibers), is important for engineering. In this study, composite materials containing the double-walled nanotube are investigated in the scope of the piecewise homogeneous body model with the use of the geometric nonlinear exact equations of the three-dimensional theory of elasticity. The investigation involves stress analysis on the outer surface of the outer layer of the carbon nanotube (CNT) and on the matrix intersection, and non-ideal contact conditions between CNT and the matrix are used. Van der Waals forces which exist between the CNT walls are considered. The results include the impact of the geometric linearity and geometric nonlinearity on the parameters of the problem at the interface of the study. Numerical results on the influence of the problem parameters on the stress distribution are presented and discussed. The effect of van der Waals force on the stresses is shown by comparison with the case where the interlayer gap is disregarded and full contact between the CNT is assumed. It is seen that the maximum absolute values of the stress increase significantly when there is no van der Waals force. In addition, it has been observed that the values of the stress change monotonically with the increase of the thickness of the nanotube. Moreover, it is established that the increase of elasticity constants significantly affects the stresses.

Spiral Buckling of Torque and Axial Force-Prestressed Nanotubes

Effect of small length scale on elastic buckling of multi-walled carbon nanotubes under radial pressure

Deformation and Bifurcation Analysis of Boron-Nitride Nanotubes

Torsional Buckling of Multi-Walled Carbon Nanotubes under Combined Axial and Radial Loadings

Continuum Modeling of Boron Nitride Nanotubes

Combined Torsional Buckling of Multi-Walled Carbon Nanotubes Coupling with Axial Loading and Radial Pressures

Twist-Direction-Dependent Buckling Behaviors of Single-Walled Carbon Nanotubes

Dynamic Buckling Analyses of Functionally Graded Carbon Nanotubes Reinforced Composite (FG-CNTRC) Cylindrical Shell under Axial Power-Law Time-Varying Displacement Load

A Finite-Deformation Shell Theory for Carbon Nanotubes Based on the Interatomic Potential-Part I: Basic Theory

Bifurcation analysis of a nanotube through which passes a nanostring

Simulation of mechanical and physical properties of a carbon nanotubes bundle under the transverse compression using a chain model with the reduced number of degrees of freedom

Two Distinct Buckling Modes In Carbon Nanotube Bending

Dynamic Buckling Behavior of Multi-Walled Carbon Nanotubes Subjected to Step Axial Loading

Thermomechanical nonlinear buckling of pressure-loaded carbon nanotube reinforced composite toroidal shell segment surrounded by an elastic medium with tangentially restrained edges

Buckling Analyses of Double-Wall Carbon Nanotubes: A Shell Theory Based on the Interatomic Potential

Stress distribution in an elastic body with a locally curved double-walled carbon nanotube

Buckling of a Slender Rod Confined in a Circular Tube: Theory, Simulation, and Experiment

Effect of Bending Instabilities on the Measurements of Mechanical Properties of Multiwalled Carbon Nanotubes

Dynamic supercoiling bifurcations of growing elastic filaments

Dynamic Torsional Buckling of Multi-Walled Carbon Nanotubes Embedded in an Elastic Medium

Necking of thin-walled cylinders via bifurcation of incompressible nonlinear elastic solids