Abstract:Abstract Laser-driven X-rays as probes for high-energy-density physics spans an extremely large parameter space with laser intensities varying by 8 orders of magnitude. We have built and characterized a soft X-ray source driven by a modest intensity laser of 4 × 10 13 W/cm 2 . Emitted X-rays were measured by diamond radiation detectors and a filtered soft X-ray camera. A material-dependence study on Al, Ti, stainless steel alloy 304, Fe, Cu and Sn targets indicated 5-μm-thick Cu foils produced the highest X-ray yield. X-ray emission in the laser direction and emission in the reverse direction depend strongly on the foil material and the thickness due to the opacity and hydrodynamic disassembly time. The time-varying X-ray signals are used to measure the material thinning rate and is found to be ∼1.5 μm/ns for the materials tested implying thermal temperature around 0.6 eV. The X-ray spectra from Cu targets peaks at ∼2 keV with no emission >4 keV and was estimated using images with eight different foil filters. One-dimensional hydrodynamic and spectral calculations using HELIOS-CR provide qualitative agreement with experimental results. Modest intensity lasers can be an excellent source for nanosecond bursts of soft X-rays.

What problem does this paper attempt to address?

The problem that this paper attempts to solve is to develop a soft X - ray source driven by a low - intensity laser and to characterize it in detail. Specifically, the researchers constructed and tested a soft X - ray source generated using a moderately intense laser (\(4\times10^{13}\, \text{W/cm}^2\)). This X - ray source generates X - rays by acting on aluminum (Al), titanium (Ti), stainless - steel alloy 304 (SS - 304), iron (Fe), copper (Cu) and tin (Sn) foil targets with a single 5 - joule, 8 - nanosecond (full - width at half - maximum), 532 - nanometer pulse. The main objectives of the study are: 1. **Optimize X - ray yield**: Determine the X - ray yields produced by foil targets of different materials and thicknesses under the same laser conditions through experiments, in order to find the best X - ray source materials and conditions. It was found that the copper (Cu) foil produced the highest X - ray yield under these conditions. 2. **Understand X - ray emission mechanisms**: The emission direction and time - dependence of X - rays were studied, as well as how these properties are affected by the material and thickness of the foil. For example, the difference in emission intensity of X - rays in the laser direction and the reverse direction is significant, which is related to the opacity of the foil and the hydrodynamic disintegration time. 3. **Measure the evaporation rate of materials**: Using the ratio of the X - ray signals in the forward and backward directions, the researchers measured the evaporation rate of the foil materials and found that the maximum evaporation rate of the copper foil is approximately 1.78 micrometers / nanosecond, which implies that the thermal temperature of the material is approximately 0.6 electron volts. 4. **Estimate the X - ray spectrum**: By using an X - ray camera with different metal filters, the researchers estimated the X - ray spectrum produced by the copper target and found that the peak is located at approximately 2 kilo - electron volts, and no X - rays exceeding 4 kilo - electron volts were observed. In addition, there is no evidence of the existence of copper K - lines or helium - like, hydrogen - like emission lines. 5. **Verify simulation results**: The experimental results were verified by simulations carried out with the one - dimensional radiation magnetohydrodynamic software HELIOS - CR, especially in terms of the time signal and spectrum of X - rays. In summary, this study aims to develop an effective soft X - ray source for the calibration of detectors and diagnostic devices, especially for future applications on the Dual - Axis Radiographic Hydrodynamic Test Facility (DARHT).

Flux and estimated spectra from a low-intensity laser-driven X-ray source

Hard X-Ray Emission from Intense Femtosecond Laser-Solid Target Interactions

Clean Source of Soft X-ray Radiation Formed in Supersonic Ar Gas Jets by High-Contrast Femtosecond Laser Pulses of Relativistic Intensity

Hard X-ray source based on a high-Contrast femtosecond laser interacting with a solid foil

Enhancement and spatial characteristics of kα x-ray emission from high-contrast relativistic fs laser plasmas

X-Ray Diffraction Study of Laser-Material Interactions with an Ultrafast Table-Top X-Ray Source

Spatially and Spectrally Resolved X-ray Measurements in Intense Laser-Plasma Interactions

Experimental Investigations of Hard X-Ray Source Produced by Picosecond Laser-Irradiated Solid Target

Approaching the Lower Temporal Limit of Laser-Produced Plasma Sources for Table-Top Soft X-ray NEXAFS Measurements

Study of Cu Kαemission from Frequency Doubled Intense Femtosecond Laser-Plasma Interactions

Attosecond Inner-Shell Lasing at Angstrom Wavelengths

High Contrast Femtosecond Laser-Driven Intense Hard X-Ray Source for Imaging Application

Intense High-Contrast Femtosecond K-Shell X-Ray Source from Laser-Driven Ar Clusters

Generation of Hard X Rays by Ultrafast Terawatt Lasers

Application of a Transmission Crystal X-Ray Spectrometer to Moderate-Intensity Laser Driven Sources

Compact laser-driven plasma X-ray source for time-resolved diffraction, spectroscopy, and imaging experiments at ELI Beamlines

RR Lyrae Stars in the Bootes dSph

Study of hard x-ray emission from intense femtosecond Ti:sapphire laser–solid target interactions

Towards performing high-resolution inelastic X-ray scattering measurements at hard X-ray free-electron lasers coupled with energetic laser drivers

Relativistic Generation and Characterization of Ultrafast X-rays for Time-Resolved Diffraction and Spectroscopy

High-flux X-Ray Photon Emission by a Superluminal Hybrid Electromagnetic Mode of Intense Laser in a Plasma Waveguide