Differential Analysis of Carburizing-Quenching Distortion of Subway Gears in the Same Furnace

Wang Xin

DOI: https://doi.org/10.1007/s11665-023-09118-3

IF: 2.3

2024-01-06

Journal of Materials Engineering and Performance

Abstract:At present the distortion was a commonly found problem for carburizing-quenching gears, and during batch processing, due to different heat transfer boundary of gears in the same furnace, there are also differences in their carburizing-quenching distortion. In this study, by measuring the flow rate at different positions of subway gear in the same furnace and the inverse heat transfer method, the heat transfer coefficient of the gears in the same furnace were obtained. In the established thermal-phase-mechanical coupled numerical model, the distortion of the gears was analyzed by the results of carbon content, temperature, and phase transformation. The differential analysis of the distortion in the same furnace was achieved, and corresponding experiments was used to validate the simulation. The results indicated that the diameter deformation of the upper and lower gears in the same furnace was relatively large, with a smaller taper. The diameter deformation of the middle gear was relatively small, with a larger taper. The placement position of the gears can be reasonably selected based on different accuracy requirements. By comparison with the experiment results, the maximum relative errors of the simulation on diameter and taper deformation were 13 and 11%, respectively. The region of range on diameter deformation in the same furnace is 0.32-0.5 mm, and the region of range on the taper is 0.1-0.2 mm.

materials science, multidisciplinary