Abstract:Conventional vehicle electronic stability control requires one steering-wheel angle sensor, one lateral acceleration sensor and one yaw rate sensor to obtain a good control performance. The control system stops working when a sensor fault is detected, which means that the vehicle runs in an unprotected state. Thus, various sensor fault diagnosis algorithms have been designed to detect and isolate the faulty sensor, but these algorithms also can be used for fault-tolerant control to preserve the safety of the vehicle. However, determining which of the different sensors is faulty is very difficult as the conventional residual comparison algorithm can only find the existence of a sensor fault but cannot locate the faulty sensor, and very few research studies have focused on this problem. In this paper, an ingenious sensor fault diagnosis algorithm is proposed. The sensor fault is detected, located and isolated by cross-checking with three different yaw rate estimates. The steering-wheel angle observer and the lateral acceleration observer are designed to provide corresponding estimated sensor signals which are employed to estimate the different yaw rates by using an extended Kalman filter. A novel decision-making process is carefully designed to locate the faulty sensor based on the different yaw rate residuals. Electronic stability control is not interrupted as the faulty sensor signal is reconfigured by the estimated signal. Experimental tests on a real car show that the proposed algorithm is efficient for detecting the sensor fault and identifying which sensor is faulty. Simulations show that the vehicle stability control strategy based on the proposed sensor fault-tolerant control algorithm has a better performance than the traditional control strategy does.

Robust Fault Estimation of Vehicular Yaw Rate Sensor Using a Type-2 Fuzzy Approach

Robust observer based fault detection for a ship rudder servo system

Effective Model Based Fault Detection Scheme for Rudder Servo System

Adaptive Proportional Integral Observer Design for Interval Type 2 Takagi–Sugeno Fuzzy Systems

Pressure Sensor Fault Diagnosis by Using Adaptive Robust Observers

Robust Fault Estimation for Singularly Perturbed Systems with Lipschitz Nonlinearity

Robust fault diagnosis and fault-tolerant control for nonlinear quadrotor unmanned aerial vehicle system with unknown actuator faults

Fuzzy adaptive fault diagnosis and compensation for variable structure hypersonic vehicle with multiple faults

Model-based Sensor Fault Detection and Isolation Method for a Vehicle Dynamics Control System

Fault diagnosis and fault tolerant control for distributed drive electric vehicles through integration of active front steering and direct yaw moment control

Observer-Based Fault Diagnosis and Fault-Tolerant Tracking Control for T-S Fuzzy Uncertain System Affected by Simultaneous Sensor and Actuator Faults

Fast actuator and sensor fault estimation based on adaptive unknown input observer

Adaptive Fault Estimation for the Motorized Cylinder of the Electro- Hydraulic Braking System with Disturbances

Adaptive Adjustable Dimension Observer Based Fault Estimation for Switched Fuzzy Systems with Unmeasurable Premise Variables

Reliable Sideslip Angle Estimation of Four-Wheel Independent Drive Electric Vehicle by Information Iteration and Fusion

Adaptive Event-Triggered Interval Type-2 T-S Fuzzy Control for Lateral Dynamic Stabilization of AEVs With Intermittent Measurements and Actuator Failure

Robust Fault Estimation and Fault‐Tolerant Control for a Class of Fuzzy Singularly Perturbed Systems With State Time Delay Based on Learning Observer

Estimating the Faults/Attacks using a Fast Adaptive Unknown Input Observer: An Enhanced LMI Approach

Fault Estimation Method for Nonlinear Time-Delay System Based on Intermediate Observer-Application on Quadrotor Unmanned Aerial Vehicle

EKF-Neural Network Observer Based Type-2 Fuzzy Control of Autonomous Vehicles

Active Fault-Tolerant Control for a Quadrotor with Sensor Faults