Abstract:Discharge chamber length is one of the factors in electron cyclotron resonance ion thruster performance optimization. It adjusts the distance between bulk plasma and grid system to change the plasma density upstream the screen grid, which will impact the ion beam current and focusing state to achieve optimization purpose. However, new evidence shows discharge chamber length play an important role in ionization during ion beam extraction, which means the effect of discharge chamber length on the performance of electron cyclotron resonance ion thruster should be renewed. After applying grid voltages, another high electron temperature region located upstream the screen grid is observed in the integrated simulation using particle-in-cell with Monte Carlo collision method, while traditional discharge chamber simulation has not seen that. The paper believed that the high electron temperature region exists objectively, because the Child-Langmuir sheath will repel electrons moving towards screen grid back to magnetic mirrors again. Those electrons will gain energy from microwave, and finally form a high electron temperature region along the Child-Langmuir sheath. This phenomenon implies that discharge chamber length can adjust the high electron temperature distribution upstream screen grid to impact the plasma generation. Therefore, the paper systematically studies the influence mechanism of discharge chamber length on discharge and ion beam performance of thruster by adopting the integrated simulation. In this paper, three ion thrusters with different discharge chamber length are simulated. Under the conditions of same magnetic field and operation parameters, the electron energy gain, plasma parameter distributions and ion beam current are compared. The results show that shorter discharge chamber length has higher electron energy gain, plasma density and voltage, but less ion beam current. This abnormal phenomenon also be seen in experiments. By analyzing the ionization rate inside the chamber, it can be seen that high-temperature electrons upstream screen grid make a significant contribution on ionization. And thus, a little bit longer discharge chamber length with lower plasma density inside the chamber has bigger ion beam current for having higher plasma density upstream the screen grid. According to this phenomenon, an electron heating mode is proposed:electrons gain energy by reciprocating through the electron cyclotron resonance layer between the Child-Langmuir sheath and magnetic mirrors. This heating mode can be used as a supplement to the electronic constraints outside the magnetic mirrors to improve the energy utilization efficiency of the thruster, which can provide a new idea for the electron cyclotron resonance ion thruster design in the future.

Study of electrostatic septum design and its high-voltage discharge protection

Electrode Geometry Optimization in Wire-Plate Electrostatic Precipitator and Its Impact on Collection Efficiency

Influence of Discharge Gap on the Discharge Stability in a Short Vacuum Arc Ion Source.

Design of Multigap Pseudospark Discharge-Based Plasma Cathode Electron Source at Different Configurations of Electrode Apertures

Radiation transport calculations for the European Spallation Source accelerator environment

Design and experimental study of electron beam treatment for composite insulator sheds

Study of cathode emission surface defects in relativistic magnetrons

Design and Research of Secondary Electron Emission Test Equipment with Low Electron Energy

S-band high-gradient low single-periodic magnetically coupled standing-wave accelerating structure for a proton therapy linac

The Effect of Electron Distribution Function Anisotropy on Space Charge Saturated Sheath Critical Parameters in Hall Thrusters

Numerical study on the effects of discharge parameters on vacuum arc plasma

Design, fabrication, and cold test of an S-band high-gradient accelerating structure for compact proton therapy facility

RADIATION SHIELDING STUDY FOR THE VERTICAL TEST SYSTEM FOR SUPERCONDUCTING RF CAVITIES

Design of Ionization Chamber for CLAPA II

[Research on Electromagnetic Compatibility Immunity Testing Methods for Proton Therapy System]

Diagnostic and Detectors for Charging and Damage of Dielectrics in High-gradient Accelerators

Dielectric Assist Accelerating Structures for Compact Linear Accelerators of Low Energy Particles in Hadrontherapy Treatments

Study on the Radiation Problem Caused by Electron Beam Loss in Accelerator Tubes

Experimental Study of residual radioactivity induced in SFC Electrostatic Deflector

Study on the effect of discharge chamber length on the performance of electron cyclotron resonance ion thruster

Effect of Deposited Charge on Vacuum DC Surface Flashover Under Electron Beam Irradiation