Enhanced Maximum Power Point Reaching Method for Passive Magnetic Energy Harvesters Operating Under Low Primary Currents

Alexander Abramovitz,Moshe Shvartsas,Alon Kuperman

DOI: https://doi.org/10.1109/tpel.2024.3376540

IF: 5.967

2024-01-01

IEEE Transactions on Power Electronics

Abstract:The letter concerns clamped-type passive magnetic energy harvester (MEH), supplying power to a general load via diode bridge rectifier (DBR). It is known that certain value of output MEH voltage (referred to as optimal) maximizes harvested power. Under high primary current magnitudes, the optimal voltage value is constant, i.e. current independent. Consequently, it was recently proposed to interface a passive MEH to a general load via switching power converter whose input (i.e. MEH-side) voltage is regulated to a corresponding constant voltage reference, realizing the maximum power point reaching (MPPR) method. However, optimal voltage value becomes current-dependent under low primary current magnitudes. As a result, the power harvested by MPPR-operated MEH becomes suboptimal if MEH-side voltage reference of the converter remains unchanged. Hence, the brief suggests allowing the converter input voltage reference value to be adjusted (by e.g. maximum power point tracking loop) to maximize harvested MEH power under low primary currents as well. Experimental results comparing harvested power of a passive MEH under classical and enhanced MPPR methods validate the proposed enhancement.

engineering, electrical & electronic