In-situ confinement of ultrasmall SnO2 nanocrystals into redox-active polyimides for high‐rate and long-cycling anode materials

Qian Liu,Zongying Xiao,Xun Cui,Qing Zhang,Yingkui Yang

DOI: https://doi.org/10.1016/j.coco.2020.100561

IF: 8

2021-02-01

Composites Communications

Abstract:<p>SnO₂ as a promising anode material possesses a high theoretical capacity and a safe lithiation potential; however, it suffers from low cycle stability and poor rate capability due to its nano-aggregation effect, structural instability, and sluggish electrode kinetics. Herein a one-pot hydrothermal process was developed to craft ultrasmall SnO₂ nanocrystals uniformly encapsulated in the polyimide matrix through a facile <em>in-situ</em> polymerization. The polyimide phase can suppress the over growth of SnO₂ nanoparticles while preventing from their re-aggregation through the space-confined effect during the material synthesis. The robust polyimide matrix can be also served as a protective layer to relieve the volume change of SnO₂ nanoparticles and inhibit the cracks propagation throughout the whole electrode during the charge/discharge processes. Moreover, the carbonyl-contained polyimide is intrinsically redox-active, capable of affording acceptable ionic conduction ability. Remarkably, the as-fabricated SnO₂@PI composite anode exhibits a reversible capacity as high as 897 mAh g⁻¹ at 0.1 A g⁻¹ and a high rate capability (479 mAh g⁻¹ at 2.0 A g⁻¹) with a higher retention (53%) than pure SnO₂ (39%). The SnO₂@PI anode also retains a capacity of 653 mAh g⁻¹ at 0.5 A g⁻¹ after 150 cycles. This work would offer an alternative strategy by incorporating metal oxide nanoparticles into the redox-active polymer matrix for advanced anode materials with high rate capability and long-term cyclability.</p>

materials science, composites