Abstract:This study aims the development of photoelectrodes to be incorporated in a photoelectrocatalytic ozonation (PECO) process for tertiary treatment of urban wastewaters, targeting the removal of contaminants of emerging concern (CEC). PECO tests were performed using urban wastewater after secondary treatment fortified with Cefadroxil (CFX, C16H17N3O5S), as target model CEC. Three Nitrogen and Carbon doped TiO2 (CN-TiO2) electrodes were synthesized by anodizing at 50, 70, and 90 V, and calcined. These materials were characterized by X-Ray diffraction and Rietveld refinement, Scanning Electron Microscopy, Diffuse Reflectance Spectroscopy, X-ray photoelectron spectroscopy, chronoamperometry, and electrochemical impedance spectroscopy, to correlate defects with photoactivity. All photoanodes considerably reduced their main bandgaps by the incorporation of C and N species, to enable absorption capacities in the UV region using a Xe lamp. The lowest oxygen vacancy content and largest crystallite size were found for CN-TiO2-70, favoring the reduction of bulk defects that could act as recombination of charge carriers. Therefore, oxygen vacancies affect more the TiO2 photoactivity compared to the crystallite size or the light absorption capacity, confirming that a lower content of vacancies in the material bulk and surface doping significantly influence the activity as detected by Rietveld refinement, DRS, and XPS. The electrochemical techniques confirm that the highest photocurrent was obtained for CN-TiO2-70, whence this photoanode was chosen to carry out the CFX degradation. A point defect model simulating Nyquist plot reveals that the photoactivity depends on the speed to diffuse oxygen vacancies through the TiO2 coating. All abatement processes were followed by high-performance liquid chromatography, and Total Organic Carbon (TOC). At neutral and alkaline conditions, CFX is eliminated to levels below the analytical detection limit after 90 min of treatment (TOC removals of 87 and 91%, respectively), indicating that the coupling between the CN-TiO2-70 photocatalyst and ozone is effective in eliminating the contaminant due to parallel routes forming •OH species. Lower CFX degradation observed at acidic pH (TOC removal of 70%) is assigned to the difficulty of oxidizing protonated CFX species.

Efficient catalytic activity of NiO and CeO2 films in benzoic acid removal using ozone

Insight into the Promotional Effect of CE Doped in (feconicrmn)3o4 High Entropy Oxides for Solvent-Free Aerobic Oxidation of Benzyl Alcohol

Controlled Synthesis of Niobium and Rare Earth Mixed Oxides for Catalytic Combustion of Chlorinated Vocs in the Synthesis Process of Polyether Polyol and Polyurethane

Enhanced Ozonation of Polystyrene Nanoplastics in Water with CeOx@MnOx Catalyst.

Mofs-derived CuCeOx Supported on H-zeolite Socony Mobile-5 for Catalytic Oxidation of 1,2-Dichlorobenzene

Γ-Al2o3 Doped with Cerium to Enhance Electron Transfer in Catalytic Ozonation of Phenol

Preparation of mesoporous Ce-Ti oxide millispheres for efficient catalytic ozonation: Performance and mechanism

[Effect and Mechanism of Removal of Trace P-Chloronitrobenzene in Aqueous Solution by ZnOOH/O3].

Efficient catalytic ozonation for ibuprofen through electron-deficient/rich centers over cerium-manganese doped carbon

Enhancement of light-driven adsorption efficacy through the integration of NiCo2O4 onto CeO2 for photo-ozone catalytic degradation of toluene

Ozone-initiated degradation of 1,2-dichlorobenzene over ceria-supported manganese, nickel, vanadium and iron catalysts

The Mechanism of Synergistic Effect on Electron Transfer over Co-Ce/MCM-48 during Ozonation of Pharmaceuticals in Water.

Effect of impregnation strategy on structural characteristics of Ce–Mn/Al2O3 and its catalytic ozonation of benzoic acid

Influence of oxygen vacancies, surface composition, and crystallite size on the photoelectrochemical oxidation activity of C,N-codoped TiO2 for cefadroxil abatement along with O3

Catalytic ozonation of sulfamethazine antibiotics using Ce0.1Fe0.9OOH: Catalyst preparation and performance

Fe 3 O 4 / Multi-Walled Carbon Nanotubes As an Efficient Catalyst for Catalytic Ozonation of P-Hydroxybenzoic Acid

Elimination of 1,2-dichloroethane over (Ce, Cr)xO2/Nb2O5 catalysts: synergistic performance between oxidizing ability and acidity

Synergistic mechanism of supported Mn–Ce oxide in catalytic ozonation of nitrofurazone wastewater

High Catalytic Performances of CeO2–CrOx Catalysts for Chlorinated VOCs Elimination

The role of WOx and dopants (ZrO2 and SiO2) on CeO2-based nanostructure catalysts in the selective oxidation of benzyl alcohol to benzaldehyde under ambient conditions

TiO2-coated CeCoOx-PVP catalysts derived from Prussian blue analogue for synergistic elimination of NOx and o-DCB: The coupling of redox and acidity