Abstract:Accurate modelling of spray combustion process is essential for efficiency improvement and emissions reduction in practical combustion engines. In this work, both unsteady Reynolds-averaged Navier-Stokes (URANS) simulations and large eddy simulations (LES) are performed to investigate the effects of spray and turbulence modelling on the mixing and combustion characteristics of an n-heptane spray flame in a constant volume chamber at realistic conditions. The non-reacting spray process is first simulated with URANS to investigate the effects of entrainment gas-jet model on the penetration characteristics and fuel vapor distributions. It is found that the droplet motion near the nozzle has significant influence on the fuel vapor distribution, while the liquid penetration length is controlled by the evaporation process and insensitive to gas-jet model. For the case considered, both URANS with the gas-jet model and large eddy simulations can properly predict the vapor penetration. For the combustion characteristics, it is found that LES yields better predictions in the global combustion characteristics. The URANS with gas jet model yields a comparable flame length and lift-off-length (LOL) to LES, but results in a larger ignition delay time compared to the experimental data. Another focus of this work is to qualify the convergence characteristics of the dynamic adaptive chemistry (DAC) method in these transient combustion simulations, where DAC is applied to reduce the mechanism locally and on-the-fly to accelerate chemistry calculations. The instantaneous flame structures and global combustion characteristics such as ignition delay time, flame lift-off length and emissions are compared between simulations with and without DAC. For URANS, good agreements are observed both on instantaneous flame structures and global characteristics. For LES, it is shown that the errors incurred by DAC are small for scatter distributions in composition space and global combustion characteristics, while they may significantly affect instantaneous flame structures in physical space. The study reveals that for DAC application in transient simulations, global or statistic information should be used to assess the accuracy, such as manifolds in composition space, conditional quantities and global combustion characteristics. For the cases investigated, a speed-up factor of more than two is achieved by DAC with a 92-species skeletal mechanism with less than 0.2 % and 3.0 % discrepancy in ignition delay and LOL, respectively.

Towards sodium combustion modelling with liquid water

Low Mach number lattice Boltzmann model for turbulent combustion: flow in confined geometries

Assessing an Experimental Approach for Chemical Explosive Mode and Heat Release Rate Using DNS Data

Direct Numerical Simulation of a Spatially Developing N-Dodecane Jet Flame under Spray A Thermochemical Conditions: Flame Structure and Stabilisation Mechanism

Direct numerical simulation of three-dimensional swirling n-heptane spray flames

Numerical Evaluation of Sodium Droplet Swarm Combustion and Its Modeling Optimization

Numerical Simulation for Combustion of Droplet with Volume of Fluid Formulation

Modeling Droplet Vaporization and Combustion with the Volume of Fluid Method at a Small Reynolds Number

Direct Numerical Simulations and Analysis of Three-Dimensional N-Heptane Spray Flames in a Model Swirl Combustor

Modeling of Emulsion Droplet Vaporization and Combustion Including Microexplosion Analysis

Flamelet LES of Swirl-Stabilized Oxy-Fuel Flames Using Directly Coupled Multi-Step Solid Fuel Kinetics

Influence of micro-explosions on the stability of laminar premixed water-in-fuel emulsion spray flames

Interface-resolved simulation of the evaporation and combustion of a fuel droplet suspended in normal gravity

Comparison and analysis of combustion characteristics and interference effect between single burning sodium jet and the dual-jets

Effects of Spray and Turbulence Modelling on the Mixing and Combustion Characteristics of an N -Heptane Spray Flame Simulated with Dynamic Adaptive Chemistry

Droplet Group Combustion Model Improvement for Sodium Spray Fire Pre-Combustion Analysis

Prediction of sodium leakage droplet size distribution in sodium-cooled fast reactor loop

Towards pore-scale simulation of combustion in porous media using a low-Mach hybrid lattice Boltzmann/finite difference solver

A new robust modeling strategy for multi-component droplet heat and mass transfer in general ambient conditions

Numerical Study of the Counterflow Diffusion Flames of Methanol Hydrothermal Combustion: the Real-Fluid Effects and Flamelet Analysis

Numerical Simulation of Liquid-Fueled Detonations by an Eulerian–Lagrangian Model