Uniaxial compression of a highly crushable granular material - a 3D DEM study

M. Stasiak
2019-07-12
Abstract:The National Agency for Radioactive Waste Management (FR Andra) in France suggested a new way to design a tunnel lining, especially, beneficial in the case of very deep tunnels. To avoid very thick tunnel segments, they propose to integrate a layer of granular material on the extrados of the thinner lining. This approach takes the advantages of the compressible capacity of the crushable particles and the load transfer in the granular material. A tunnel segment with such design is called a Mono-block Compressible Arch-segment VMC (Andra’s & CMC’s pending patent) and is an innovative new type of tunnel linings.This PhD dissertation is dedicated to the creation of a numerical model capable of reproducing the mechanical behaviour of this compressible granular layer using 3D Discrete Element Method (DEM). The granular packing is made of the brittle hollow coarse-size cylindrical particles, called shells. Each shell is a 2 cm long tube with a diameter of 2 cm. Its small thickness makes the cylindrical shell mainly made of void surrounded by a thin layer of clay. In the model, a breakable cluster (shell) is generated using sphero-polyhedral elongated clumps. These clumps, called sectors, are glued together using two adhesive contact force laws. If the combination of the normal and tangential contact forces exceeds a suitable failure criterion, a de-clustering of the shell (breakage) occurs. The DEM tool Rockable devel- oped for this research can operate on such crushable particles. The mechanical properties of the shell model, composed of 12 to 24 sectors, are adjusted in the case of a uniaxial (vertical) radial compres- sion of shells. The preceding grain-scale experiments on the true shells made of baked clay serve as a reference. We determine the true range of the failure tensile load and its statistical Weibull distribu- tion. The user-specified parameters is then successfully validated in the case of radial compression of a horizontally constrained shell.Firstly, the macroscopic study of shell assemblies focuses on the experimental characterisation of the samples with a control of the initial state variables like a number density and a spatial arrangement of shells (shells orientations). 3D reconstruction from X-ray tomographies of the original coated shells samples extracted from the extrados of a tunnel segment help us to characterise the anisotropy of the shells orientation. This is a piece of valuable information to the generation the numerical samples of shells with relevant initial features. Secondly, a series of DEM oedometric tests on ⟨1 000 : 2 000⟩ shells is simulated. A parametric study successfully leads to the understanding of each internal state variable role. A well-chosen set of initial variables with properly adapted DEM parameters give the relevant predictive simulations for a final comparison with the experimental oedometer tests. Thanks to a discrete insight into the micromechanics, the evolutions of the breakage level, the orientation anisotropy and the local stresses exerted on the shells (and/or the fragments) are quantified during the compression. The breakage of the shells result in high compressibility of the material. Therefore, the mechanical response is seen as a consequence of the breakage evolution. Finally, an analytical model is suggested in order to predict the Stress↔Void ratio relationship knowing the initial state of the sample and the tensile strength of the constituents: the shells.
Engineering,Environmental Science,Materials Science
What problem does this paper attempt to address?