Abstract:Parameter values adopted in railway engineering analysis at present are generally obtained through triaxial tests, whereas the remarkable difference between the actual stress path during train passage and the loading path in cyclic triaxial tests may lead to inaccurate predictions and even engineering problems. Published researches show that the actual stress path probably contains principal stress rotation(PSR), which has a sisgnificant influence on the mechanical response of soil. However, the conventional approach, i.e. cyclic triaxial test is not efficient in simulating this complicated stress path involving PSR. Instead, hollow cylinder test with cyclic shear stress has been proved to be an excellent selection for PSR study. In order to obtain reliable stress path for guiding hollow cylinder tests, three-dimensional calculation for a certain urban railway is carried out; and the distribution regularity of cyclic stress amplitudes, cycle numbers and PSR under train loads is analyzed. Furthermore, a series of cyclic torsional shear tests on hollow cylinder samples is employed to simulate the complex stress path and to research the deformation and pore pressure accumulation properties of saturated soft clay. Considering stress in foundation soil decreasing along with the depth increasing, various cyclic stress amplitudes corresponding to different depths are adopted in this experiment study. Three-dimensional calculation shows that the major principal stress axis will rotate from -90 degrees to 90 degrees during the train loading passage as well as the number and amplitude of stress waves reduce gradually with the increase of depth. It is also shown that both PSR and stress are quite sensitive to train loads as the upper soil element can identify a single wheel load while the lower soil element can just identify a bogie and even the whole train load. And through the cyclic torsional shear tests, it's obvious that the rotation of principal stress can promote the accumulation of pore pressure and strain in soft soil foundations significantly; and in the case when vertical cyclic stress amplitude equals to 15 kPa, the pore pressure and strain in cyclic torsional shear test are 77% and nearly 50% higher than that in cyclic triaxial test respectively. What's more, as the cyclic stress amplitude increases, the gap of cumulative pore pressure and strain between that two types of tests will enlarge further, which may even result in essential difference that samples in triaxial tests show only small strain whereas failure in torsional shear tests.

Parameter identification of overhead conductor rail support and its influence on the contact forces

Three-dimensional Finite Element Simulation on Moving Load Induced Track Response over Stiffness-varied Base

Assessment of Dynamic Interaction Performance of High-Speed Pantograph and Overhead Conductor Rail System

Three-dimensional contact formulation for assessment of dynamic interaction of pantograph and overhead conductor rail system

The Effect of High-Frequency Parametric Excitation on A Stochastically Driven Pantograph-Catenary System

Vertical dynamics of a pantograph carbon-strip suspension under stochastic contact-force excitation

Effects of the Dynamic Wheel–rail Interaction on the Ground Vibration Generated by a Moving Train

DYNAMIC RESPONSE ANALYSIS OF TRACK SYSTEM AND UNDERGROUND RAILWAY TUNNEL IN SATURATED SOIL SUBJECTED TO A MOVING TRAIN LOAD

A Combination Strategy of Hollow-Closed-wall In-Filled Trench and Elastic Bearing for Reducing Environmental Vibration Induced by High-Speed Train

Impact of Aerodynamics of Pantograph of a High-Speed Train on Pantograph-Catenary Current Collection

Influence of a high-speed train passing through a tunnel on pantograph aerodynamics and pantograph–catenary interaction

Research on mechanical response of soft clay under cyclic loading involving principal stress rotation

Dynamic Characteristics Analysis of Double Pantograph Catenary of AC Rigid Catenary System

Dynamic Response Study of Overhead Contact System Portal Structure Based on Vehicle–Track–Bridge Coupled Vibration

A study on the optimal spatial damping distribution in railway pantograph-catenary interaction

Dynamic Performance Simulation of Overhead Contact System for over 350km/h High-Speed Rail

Validation of a new model for railway overhead line dynamics

Mechanical Parameter Optimization of Interphase Composite Spacer Used for Controlling Conductor Galloping

Hunting stability and dynamic stress analysis of a high-speed bogie using elastic-suspended motors as dynamic vibration absorber

Discrete Element Modeling of a Cross-River Tunnel under Subway Train Operation During Peak and Off-Peak Periods

A comparative study on the influence of typical track failures on high-speed pantograph-catenary interaction dynamics