Pocket housing for sliding door

이영호,장화균
2004-12-01
Abstract:The subject innovation can reduce the assembly time and at the same time enhancing the structural strength increase to improve the durability by city easily can be prevented from rocking cut off or deformed, installed by the assembly of the wall so that simply made from external impact assembly efficiency of the wall to provide a pocket housing the sliding door improve the workability. Pocket housing 10 of the present design is installed on the cloth fixture (3) the upper guide frame 11 and 12 and a bottom checheuk installed on the side that slidably guide the roller 5 of the sliding door (1) walls of both place and the lower guide frames (11, 12) for guiding the lower end of the sliding door (1), the distance which the sliding door (1) may be provided between the immersion cloth congestion and bottom body (20a, 20b) and a. In addition, the walls (20a, 20b) is, the outer side of the sliding door (1) the intervals, which can be immersed disposed on either plywood (21a, 21b) and the laminate (21a, 21b), downward constant maintain spacing tip side vertical frame for fixing the both ends of the installation and screwing a plurality of reinforcing pipes (22a, 22b) has a blank square cross-sectional shape in the horizontal direction, the plurality of reinforcing pipes (22a, 22b) (25a, 25b) and the rear end of the vertical frame (26a, 26b) and the first and the second gypsum board is arranged on the outside of the plurality of reinforcing pipes (22a, 22b) being provided between the cloth congestion and bottom member (23a, 23b, 24a , consists 24b).
Geology,Engineering
What problem does this paper attempt to address?