Abstract:A speed regulator that can transmit torque between intersecting axes with non‐contact characteristics is proposed. The torque is generated by the magnetic force between magnets and induced eddy current, and the speed can be regulated by changing the air gap or coupling area. The torque model considering variable air gap is established based on the equivalent magnetic circuit method. The permanent magnet eddy‐current coupler (PMEC) is a kind of non‐contact, stepless speed regulation device and has been widely used in transmissions. However, the current PMECs are coaxial and cannot achieve transmission and speed regulation in intersecting axes. An intersecting‐axis permanent magnet (PM) eddy current coupler (IPMEC), which consists of a disk‐type PM rotor and a barrel‐type conductive sheet (CS) rotor arranged with intersecting axes, is proposed. It generates eddy currents through the speed difference between the two rotors and uses the non‐contact electromagnetic force between the eddy currents and permanent magnets to transmit torque. During operation, the speed can be adjusted by altering the coupling area or air gap. A theoretical model of the IPMEC based on the equivalent magnetic circuit method is presented and verified by finite element simulation using ANSYS. Then, the effects of the pole number of the PMs, the radius of the CS rotor and the PM rotor on the performance were analysed, and the design method of the IPMEC was proposed. This study can be used to expand the application range of PMECs.

Active Inertia Extended Resonance Ratio Control for Permanent Magnetic Coupling Transmission System

Current Control Scheme for LC-Equipped PMSM Drive Considering Decoupling and Resonance Suppression in Synchronous Complex-Vector Frame

An Adaptive Speed Control Method for Permanent Magnet Synchronous Motors

Improved 2-Order Active Disturbance Rejection Control for PMSM

Speed Control For A Permanent Magnet Synchronous Motor With An Adaptive Self-Tuning Uncertainties Observer

Permanent Magnet Synchronous Motor Control System Based on No Manual Tuned Active Disturbance Rejection Control

Multi-Objective Optimal Design of Μ–controller for Active Magnetic Bearing in High-Speed Motor

Attenuation Of Pmsm Torque-Ripple Based On Combination Of Equivalent-Input-Disturbance Approach And Sliding-Mode Control

Model Predictive Current Control with Adaptive-Adjusting Timescales for PMSMs

Multiobjective Vibration Control for the Noncollocated Active Magnetic Bearings Flexible Rotor Systems

Four-Factor Polarity Switching Control for Synchronous Vibration Suppression of Active Magnetic Bearings Rigid Rotors System in the Full Rotational Speed Range.

Permanent Magnet Synchronous Motor Maximum Torque Per Ampere Control Based on Feedback Dissipative Realization

Active Vibration Control of a Non-collocated AMBs Flexible Rotor System to Pass the First Bending Critical Speed

Vibration Control for Active Magnetic Bearing High-Speed Flywheel Rotor System with Modal Separation and Velocity Estimation Strategy

All-coefficient Adaptive Control of Active Magnetic Bearing System Based on Characteristic Model

Modelling and analysis of the intersecting axis permanent magnet eddy‐current coupler

Current Control Method of Vehicle Permanent Magnet Synchronous Motor Based on Active Disturbance Rejection Control

Robust Control Methods for PM Synchronous Motor

High Precision Low-Speed Control for Permanent Magnet Synchronous Motor

High-Precision Control For A Surface-Mounted Permanent Magnet Synchronous Motor Based On Inverse System Approach