Abstract:The use of seawater, sea sand and coral to formulate concrete for marine engineering construction is an effective measure for rationally allocating resources and alleviating resource shortages. To promote the engineering application of marine concrete, it is necessary to study the mechanical properties and microstructure of marine concrete. In this study, sea sand coral concrete (SSCC) with strength grades of C20–C40 was prepared, and the compressive and flexural tests were conducted to observe the stress process and damage morphology of the specimens and to establish a constitutive model for SSCC under uniaxial compression. In addition, the microstructures of the SSCC hydration products and interfacial transition zone (ITZ) were observed via X-ray diffraction (XRD) and scanning electron microscopy (SEM). The results showed that the damage surface of the SSCC occurred directly through the coral aggregate, and the damage process was sudden and brief. Under uniaxial compression, the trend of the rising section of the stress-strain curve of SSCC with different strength grades are basically the same, but the shape of the descending section vary greatly, and the higher the strength grade is, the steeper the slope of the descending section. Quantitative relationships between compressive strength, elastic modulus, peak strain and peak stress and cube compressive strength were established. Based on the experimental results, a two-stage uniaxial compression constitutive model for SSCC was proposed, and the established constitutive model can effectively predict the stress-strain behavior of SSCC. In addition, the XRD patterns show that the early hydration rate of SSCC is faster than that of ordinary concrete (OC), which leads to a faster early strength development of SSCC. The SEM images show that the coral aggregate binds better to the cement matrix than the crushed gravel aggregate does and that the microstructure of the SSCC is denser than that of OC.

Mesoscopic study of the mechanical properties of coral aggregate concrete under complex loads

3D mesoscopic modelling on the dynamic properties of coral aggregate concrete under direct tension

3D mesoscopic analysis on the compressive behavior of coral aggregate concrete accounting for coarse aggregate volume and maximum aggregate size

Axial Compressive Behavior and Load Carrying Capacity Prediction of Prefabricated UHPC Tube Filled with Seawater Sea-Sand Coral Aggregate Concrete

Mechanical properties and constitutive model of coral aggregate concrete subjected to dynamic uniaxial and triaxial compression

Constitutive Relations of Coral Aggregate Concrete under Uniaxial and Triaxial Compression

Effect of Aggregate Size on the Axial Compressive Behavior of FRP-Confined Coral Aggregate Concrete

Experimental Study on the Mechanical Properties and Uniaxial Compressive Constitutive Relationship of Sea Sand Coral Concrete

Dynamic Behavior of a New Type of Coral Aggregate Concrete: Experimental and Numerical Investigation

Damage-constitutive model for seawater coral concrete using different stirrup confinements subjected to axial loading

Water saturation effect on the dynamic mechanical behaviour and scaling law effect on the dynamic strength of coral aggregate concrete

Strength and Fracture Properties of Coral Concrete under Impact of Coral Aggregate Type and Fiber Hybridization

Advances in coral aggregate concrete and its combination with FRP: A state-of-the-art review

Mechanical Properties and Failure Criteria of Carbon Fiber-Reinforced Coral Concrete under Biaxial Compression

Mechanical properties of modified coral aggregate seawater sea-sand concrete: Experimental study and constitutive model

Axial Compressive Behavior of Seawater Coral Aggregate Concrete-Filled Frp Tubes

3 D In-situ XCT Image Based Mesoscale Fracture Modelling and Validation of Concrete Using Voxel Hexahedron Meshing and Damage Plasticity Model

Experimental study and numerical simulation of impact compression mechanical properties of high strength coral aggregate seawater concrete

The Study on the Whole Stress–Strain Curves of Coral Fly Ash-Slag Alkali-Activated Concrete under Uniaxial Compression

Dynamic triaxial compressive response and failure mechanism of basalt fibre-reinforced coral concrete

Enhancing Mechanical Performance and Crack Morphology of Engineered Cementitious Composites Through Tailoring Coral Sand