Abstract:BACKGROUND:Although mobile bearing knee prosthesis exhibits good movement and low wear rate in vitro studies,its clinical effect in vivo is still contraversial.OBJECTIVE:To compare and observe the range of motion and clinical outcomes of mobile bearing knee prosthesis and fixed bearing knee prothesis at least 1 year after operation.DESIGN,TIME AND SETTING:A randomized controlled observation.The experiment was performed at the Joint Reconstruction Center,Seoul National University Bundang Hospital,Seoul,Korea between November 2003 and July 2006.PARTICIPANTS:Four hundrend and eighty-eight patients(669 knees) with knee osteoarthritis undergoing total knee arthroplasty(TKA) were selected,of them 244(341 knees) were treated with fixed bearing knee prothesis and 244(328 knees) with mobile bearing knee prosthesis.METHODS:The surgery was performed by the same physician(TK Kim).With patellar medial approach,the patella was not turned over,but dislocated laterally to expose the bone.Space measurer was used to expand and measure the space.According to the measurements,soft tissues were released and balanced until the flexion gap was within 3-4 mm more than extension gap or 1-2 mm extension gap more than flexion gap.For varus knees,2-3 mm larger lateral gap was accepted.In all cases,the patella was resurfaced,and implant fixation was carried out with cement.MAIN OUTCOME MEASURES:Degrees of flexion contracture and maximum flexion angle were measured with a goniometer.The knee pain and functional status were evaluated by American Knee Society(AKS) scores,Patellofemoral scores,Western Ontario McMaster Universities Osteoarthritis Index scales(WOMAC) and SF-36 systems.RESULTS:There was no significant difference between two groups in terms of sex,age,body height,body mass and body mass index.No differences wre found in postoperative socres of Patellofemoral scores,WOMAC and SF-36 systems(P > 0.05).The mean AKS scores of fixed bearing knee prothesis group were higher than mobile group(48.5±3.2,47.5±4.8,P=0.010).The flexion defomity of two groups was significantly corrected following surgery(P=0.341).No differences were found in terms of range of motion(P=0.412) and knee function(P > 0.05).CONCLUSION:The mobile bearing design has no advantages in postoperative range of motion,pain relief and knee function relative to fixed bearing design.Surgical technique is critical to achieve good clinical outcomes.

Effect of femoral prosthesis flexion angle on unicompartmental knee arthroplasty with mobile platform

Finite element analysis of sagittal angles of unicompartmental knee arthroplasty

Finite Element Analysis of the Effect of Femoral Prosthesis Varus and Valgus Angle Installation on the Lateral Compartment in Unicompartmental Knee Arthroplasty

Biomechanical effects of femoral prosthesis misalignment on the structure of the lateral compartment during medial unicompartmental knee arthroplasty in osteoporotic patients

Biomechanical finite element analysis of various tibial plateau posterior tilt angles in medial unicondylar knee arthroplasty

Finite element analysis of tibial slope in mobile-bearing unicompartmental knee arthroplasty

The effect of tibial component rotational alignment on clinical outcomes of mobile-bearing unicompartmental knee arthroplasty

Comparison of knee joint function following total knee arthroplasty with fixed platform versus rotating platform high-flexion prostheses

Finite Element Analysis of Femoral Stress Changes after Total Hip Arthroplasty

The effect of different posterior inclinations of tibial component on tibiofemoral contact pressures after unicompartmental knee arthroplasty

Influence of the angle between tibial and prosthesis mechanical axes on tibial bone remodeling in total knee arthroplasty

Effect of design and surgical parameters variations in mobile-bearing versus fixed-bearing unicompartmental knee arthroplasty: A finite element analysis

What effect does preoperative flexion contracture have on the component angles in unicompartmental knee arthroplasty?

An MRI-Based Correlation Study Investigating the Effect of Varying Posterior Femoral Condyle Angles on the Patellofemoral Joint

Medial-lateral translational malalignment of the prosthesis on tibial stress distribution in total knee arthroplasty: A finite element analysis

Influence of hip prosthesis position on postoperative gait in symptomatic hip osteoarthritis secondary to hip dysplasia patients after primary total hip arthroplasty: a short-term follow-up study

Finite element analysis of biomechanical effects of residual varus/valgus malunion after femoral fracture on knee joint

Finite element study of stress distribution in medial UKA under varied lower limb alignment

Mobile- and fixed-bearing total knee arthroplasty for knee osteoarthritis Comparisons of early clinical outcomes

Assessing the influence of gastrocnemius reconstruction on stress distribution of femoral tumor rotating hinge knee prosthesis via finite element analysis

Prediction of postoperative range of motion after mobile-bearing medial unicompartmental knee arthroplasty from the preoperative range of motion and other preoperative factors