Revisiting strategies and their combinatorial effect for introducing peroxygenase activity in CYP102A1 (P450BM3)

Jasmin C. Aschenbrenner,Ana C. Ebrecht,Martha S. Smit,Diederik J. Opperman
DOI: https://doi.org/10.1016/j.mcat.2024.113953
IF: 4.6
2024-02-24
Molecular Catalysis
Abstract:Different strategies have previously been reported to convert cytochrome P450 monooxygenases to peroxygenases, allowing H 2 O 2 -driven oxyfunctionalization reactions. Comparison of the BM3 (CYP102A1) peroxygenase variant 21B3, obtained through enlargement of the active site by the F87A mutation followed by mutational stabilization towards H 2 O 2 , with the BM3_T268E variant, with an acid-base catalyst introduced, showed 21B3 to be the superior peroxygenase. A combination of these two strategies (21B3_T268E combinatorial mutant), however, resulted in reduced peroxygenase activity. The further introduction of the F(A)87V and A328F mutations (87–328 variants), previously reported to improve the regioselectivity of BM3 on n -alkanes, resulted in a loss of activity towards dodecanoic acid, a substrate commonly used to evaluate the activity of BM3. Although a reduction in activity was observed for styrene, the combinatorial mutants yielded higher enantioselectivities for R -styrene oxide. The activity towards α-olefins were, however, comparable between the different peroxygenase variants of BM3, but with absolute selectivity for epoxidation observed with the combinatorial mutants 21B3_87-328 and 21B3_T268E_87-382. Structural investigation of the active site architecture showed significant differences in the I-helix and heme accessibility. According to these results, future directed evolution studies will require selective pressure not only for H 2 O 2 , but also the specific substrate to be activated rather than surrogate substrates.
chemistry, physical
What problem does this paper attempt to address?