Metallic Resurfacing Hemiarthroplasty of the First Metatarsophalangeal Joint Combined with First Metatarsal Osteotomy for the Treatment of Hallux Rigidus with Hallux Valgus in China.
Jin Kaiji,Wang Yuanli,Fu Zhongguo,An Shuai,Xu Hailin,Jiang Baoguo
DOI: https://doi.org/10.3760/cma.j.issn.0366-6999.20140296
2014-01-01
Abstract:Hallux rigidus occurs mainly at the first metatarsophalangeal (MTP) joint, causing localized pain and degenerative arthritis.1 This condition frequently occurs together with hallux valgus and is difficult to treat. For hallux rigidus affecting only one joint, the treatment choices include articular debridement, resection arthroplasty, prosthetic arthroplasty, and arthrodesis, depending on the degree of arthritis. The main advantage of prosthetic arthroplasty is the restoration of functional joint motion. However, long-term follow-up showed wearing of the prostheses made of silicone and a poor driving force when walking. Metallic resurfacing hemiarthroplasty replaces only the articular surface of the proximal phalanx, with minimal bone resection.2 The proximal metatarsal surface is preserved after removal of the dorsal osteophyte. This procedure relieves pain and restores joint motion. However, as patients with hallux valgus have misalignment of the first MTP joint, the rate of hemiarthroplasty implant failure is relatively high, and hallux valgus used to be considered a relative contraindication to MTP hemi- or total joint prosthetic arthroplasty. We treated patients with metallic hemiarthroplasty combined with metatarsal osteotomy to correct the alignment of the first MTP joint and achieved good pain relief with a low complication rate. METHODS Patients Seven feet of six patients who underwent surgical treatment for hallux rigidus with hallux valgus at Peking University People's Hospital (five females) and Peking Longfu Hospital (one male) from May 2010 to February 2011 were included in the study. All patients presented with pain in the first MTP joint, limited dorsiflexion, and mild to moderate hallux valgus deformity for 6 months or longer, which was not relieved by oral non-steroidal anti-inflammatory medication, local block, physical therapy, and exercises. Physical examination showed tenderness over the first MTP joint, significantly limited dorsiflexion with pain, and mild to moderate hallux valgus. Patients with systemic disease (such as rheumatoid arthritis) or focal neuropathy were excluded from the study. Pre and postoperative evaluations were performed using the American Orthopedic Foot and Ankle Society (AOFAS) forefoot score, a visual analog scale (VAS) pain score, and radiographic assessment including the 1,2 intermetatarsal angle (IMA) and hallux valgus angle (HVA), to evaluate functional improvement and the degree of hallux valgus correction, and if there were any signs of loosening or cutout. All patients were asked at the last follow-up whether they were satisfied with the outcome. Hemi™ prosthesis The proximal phalangeal surface was replaced by Hemi™ prosthesis (OsteoMed Corp., Addison, TX, USA, Figure 1), which is a cementless press-fit implant made from a cobalt-chromium alloy. This implant has a flat stem with anti-aliasing design to prevent loosening and cutout, and the low surface profile helps to minimize bone loss during osteotomy of the articular surface. One of four sizes can be chosen, depending on the diameter of the proximal phalangeal surface (extra small, small, medium, or large).Figure 1.: The Hemi™ (OsteoMed Corp., Addison, TX, USA) hemiarthroplasty prosthesis for the proximal phalangeal surface, a cementless press-fit implant made from a cobalt-chromium alloy. This implant has a flat stem with anti-aliasing design to prevent loosening and cutout, and the low surface profile helps to minimize bone loss during osteotomy of the articular surface (A). A 75-year-old man with a 6-year history of pain when walking on the left first metatarsophalangeal joint. X-ray showed degenerative arthritis of the joint (type III) and moderate hallux valgus (B). Metallic hemiarthroplasty of the metatarsophalangeal joint combined with Chevron osteotomy of the first distal metatarsal for the treatment of hallux rigidus with hallux valgus, 1 year after surgery (C). Postoperative X-ray showing good positioning of the prosthesis and screw after 1 year. The hallux valgus angle is satisfactory and there are no signs of loosening or cutout of the prosthesis (D).Surgical techniques Patients were placed supine and surgery was performed under combined spinal and epidural anesthesia. Surgery was often performed via a 6-cm dorsomedial incision over the first MTP joint. The subcutaneous tissues were bluntly dissected to avoid damaging the cutaneous nerve. The articular capsule was sharply dissected on the medial and lateral sides to expose the first MTP joint and the proximal part of the first metatarsal bone. Typically, the hemiarthroplasty procedure would be performed prior to metatarsal osteotomy. The proximal 2–8 mm of the phalangeal articular surface was cut perpendicular to the longitudinal axis of the phalangeal bone using a pendulum saw. Adequate bone was removed to allow space for the prosthetic joint surface without joint tightness. Typically, a gauge measuring device was placed on the cut surface of the proximal phalangeal bone and used to guide formation of a hole in the center of the bone with an impactor or sliding weight. The appropriate prosthetic spacer was chosen and inserted into the intramedullary space to evaluate the joint tension and motion. If the joint was too tight, the spacer was removed and more bone was removed from the proximal phalanx. The spacer was then reinserted and the joint was reevaluated. When the tension and motion were satisfactory, the prosthesis was hammered into the bone until it was positioned correctly. The alignment and motion were reassessed, the remaining soft tissues were evaluated, and adjustments were made if necessary. For modified Chevron osteotomy of the distal first metatarsal, a temporary marker was placed at the center of the severed bone using a K-wire. A V-shaped osteotomy was formed 1 cm from the distal end of the first metatarsal on the medial side, using a pendulum saw, with the open end facing the proximal stump. The lower end of the severed bone extended to the outside of the articular capsule. The distal end of the metatarsal bone was then moved laterally by 4–6 mm, and the alignment of the first MTP joint was checked. When the HVA was satisfactory, the bones were fixed using a 2.0 or 2.4 mm cannulated screw (OsteoMed Corp.). Figure 3 shows the radiological assessment postoperation in which there were no signs of loosening or cutout. Postoperative management Prophylactic intravenous antibiotics (cephalosporin) were administered intraoperatively and for 24 hours postoperatively. Patients started to mobilize the day after surgery and wore forefoot offloading shoes for 6 weeks. If there were no signs of loosening or malalignment, patients were then able to return to full weight-bearing in normal shoes. Evaluation criteria The AOFAS forefoot score and VAS pain score were used for functional evaluations. The AOFAS score includes evaluation of pain, function, and alignment. The score ranges from 0 to 100, with 90–100 indicating excellent, 75–89 indicating good, 50–74 indicating fair, and <50 indicating poor. The VAS pain score was determined by asking patients to mark a point reflecting their level of pain on a 10-cm line marked from 0 (painless) to 10 (severe pain). Data analysis Data analysis was performed using SPSS version 20 (SPSS Inc., Chicago, IL, USA). The pre- and postoperative function and pain scores and degree of deformity were compared using paired t tests. In the patient who underwent bilateral surgery, both feet were analyzed. A value of P <0.05 was considered statistically significant. RESULTS Patient characteristics From May 2010 to February 2011, we performed metallic resurfacing hemiarthroplasty combined with metatarsal osteotomy in seven feet of six patients with hallux rigidus and hallux valgus. The mean age of patients was 60.7 years (range 53–75 years). The mean follow-up time was 24 months (range 20–30 months). One of the female patients had bilateral hallux rigidus with hallux valgus. Physical examination showed instability of the right Lisfranc joint, which was considered to be the primary cause of the hallux valgus, and there were calluses over the plantar aspects of the second and third MTP joints. In this patient, the Lapidus procedure was performed in the right foot after metallic resurfacing arthroplasty. In the other six feet, metallic resurfacing arthroplasty was combined with distal first metatarsal osteotomy with cannulated screw fixation. If there were other coexisting problems such as pain at the second and third MTP joints, Weil osteotomy was performed at the same time. Patients usually wore forefoot offloading shoes for 6 weeks, after which they could wear normal footwear. Patients were followed up at 1 month and 6 months after surgery, including evaluation of foot X-rays (for patient characteristics, Table 1).Table 1: Patient characteristicsRadiographic characteristics Figures 2–4 show the pre- and postoperative radiographic findings of one of the patients. Clinic outcome There were no postoperative complications such as infection or nonunion. No cases of necrosis of the first metatarsal head or implant failure were observed at the time of the last follow-up. Table 2 shows the pre- and postoperative IMA, HVA, AOFAS score, and VAS score for each foot. There were significant postoperative differences in the AOFAS score, VAS score, and degree of hallux deformity.Table 2: Preoperative and latest follow-up findings (mean (standard deviation))DISCUSSION In patients with hallux rigidus and hallux valgus who undergo prosthetic arthroplasty, the implant failure rate may be relatively high because of the malalignment of the first MTP joint. Hallux valgus has therefore been considered to be a relative contraindication to prosthetic arthroplasty for hallux rigidus. There are currently no reported studies of treatment for hallux rigidus with hallux valgus using prosthetic arthroplasty. We focused on correcting the hallux valgus deformity and improving the alignment of the first MTP joint by metatarsal osteotomy, thereby creating good conditions for arthroplasty. When performing metallic hemiarthroplasty, it is important to choose a prosthesis that matches the size of the articular surface, to avoid impingement with dorsiflexion. The osteophyte on the dorsal distal metatarsal should also be removed to avoid postoperative impingement. A dorsomedial incision over the MTP joint was chosen in all six patients in this study, and care was taken to protect the cutaneous nerve. The patients all underwent soft tissue release on the lateral side of the MTP joint, with correction of the HVA to the normal range. When performing hemiarthroplasty, we chose a relatively smaller prosthesis in the context of ensuring matching with the articular surface, as discussed above. There were no cases of infection, nonunion, implant loosening, implant failure, transfer metatarsalgia, or nerve injury at the 6-month postoperative follow-up. Dorsiflexion, range of motion, and pain relief improved significantly after surgery, and patients were able to wear normal shoes. The AOFAS and VAS scores improved significantly, and all patients felt satisfied with the outcome. So far this is the first case series that reported the application of hemiarthroplasty for the treatment of hallux rigidus with hallux valgus in China. Six of the feet in this study had end-stage hallux rigidus with mild to moderate hallux valgus, and metallic hemiarthroplasty combined with modified Chevron osteotomy of the distal first metatarsal was performed. The other foot had end-stage hallux rigidus with instability of the first tarsometatarsal joint, and metallic hemiarthroplasty combined with fusion of the first tarsometatarsal joint (Lapidus procedure) was performed. A mild to moderate degree of hallux valgus indicates an IMA of ≤16° and an HVA of ≤35°. In patients with severe hallux valgus, indicating an IMA of >16° or an HVA of >35°, modified Chevron osteotomy may not be sufficient to correct the deformity, and proximal metatarsal osteotomy or a Lapidus procedure may be required. In patients who underwent distal metatarsal osteotomy, the metatarsal surface of the MTP joint could not be replaced, and hemiarthroplasty of the proximal phalanx was therefore performed. This study included only a small number of patients because of the strict inclusion criteria. Our short-term outcomes are encouraging, but further studies with larger patient numbers and longer follow-up periods are needed to further evaluate this treatment.