Abstract:Cellulose nanocrystal and chitosan blended Nanocomposite for dye removal. Development of a cost‐effective and environmentally friendly method to treat dye wastewater is of utmost importance. In this experimental study, wastepaper was used as the raw material for the extraction of cellulose nanocrystals to fabricate a nanocomposite membrane with chitosan. During the extraction process, acid hydrolysis (Sulfuric acid) followed by bleaching (hydrogen peroxide) was adopted. To confirm the nano‐range, particle size analysis, and FESEM were performed, which confirmed the presence of particles in the nano‐range ranging from 313.8 to 122.1 nm and FESEM observed results showed transformation of fibrous to rod shaped nanocrystals after acid hydrolysis. After successful nanocomposite fabrication a porous sieved network of membrane was observed and after adsorption successful adhesion of dye molecules over the membrane matrix was also confirmed. FTIR data showed that during adsorption mechanism some of the prominent peaks gets disappeared suggest interaction of dye molecules onto the nanocomposite. The contact angle of 21.0° was observed for the ChNC3 nanocomposite showed super hydrophilic behavior. Tensile strength was also observed in terms of young's modulus, ultimate strength, and elongation at break. The elasticity and stiffness of a material are usually indicated by its young modulus. In AH CNCs and ChNC3, the young modulus was seen to be increasing from 195 0.316, respectively. Furthermore, the potentiality of the nanocomposite membrane was analyzed for Congo red dye in synthetic wastewater prepared in the laboratory. During the batch study, various working parameters were taken such as initial dye solution (20–100 ppm), pH (1–7), contact time (10–60 min), and dosage (0.1–0.5 mg/L). To know about adsorption, Langmuir and Freundlich isotherm were analyzed it was observed that Freundlich isotherm show best fitted modeling with R2 = 0.99, and n = 1.6 showing favorability of the heterogeneous adsorption. To determine the interaction between the adsorbate and adsorbent, pseudo first order and pseudo second order kinetics models were analyzed, and it was observed that chemisorption interaction followed between the adsorbate and adsorbent. Thermodynamic parameters were analyzed, which confirmed the spontaneous and favorable adsorption mechanism. To avoid fouling problems and maintain cost effectiveness, the resulting, nanocomposite membrane was desorbed using an appropriate solvent. After 5 cycles, the desorption rate decreased from 54% to 38%. This developed nanocomposite membrane appears to be effective in effluent waste treatment because of its simple formulation approach.

Nanocellulose-Based Ecofriendly Nanocomposite for Effective Wastewater Remediation: A Study on Its Process Optimization, Improved Swelling, Adsorption, and Thermal and Mechanical Behavior

Novel wastepaper nanocellulose/chitosan‐based nanocomposite membrane for effective removal of the textile dye Congo red from aqueous solution

Sweet lime peel biomass derived nano-cellulose for dye removal: Kinetics, thermodynamics, optimization and toxicity studies

Cellulose-based hydrogel for adsorptive removal of cationic dyes from aqueous solution: isotherms and kinetics

Fabrication of eco-friendly nanocellulose-chitosan-calcium phosphate ternary nanocomposite for wastewater remediation

Nanocellulose: A comprehensive review investigating its potential as an innovative material for water remediation

Modified gum ghatti based hybrid hydrogel nanocomposite as adsorbent material for dye removal from wastewater

Linear and nonlinear regression modelling of industrial dye adsorption using nanocellulose@chitosan nanocomposite beads

Cellulosic biomass-based sustainable hydrogels for wastewater remediation: Chemistry and prospective

Sugarcane cellulose-based composite hydrogel enhanced by g-C3N4 nanosheet for selective removal of organic dyes from water

Enriched removal of cationic and anionic dyes using 4-nitro cinnamaldehyde loaded hydroxyapatite with hematite nanocomposites

Development of new organic-inorganic, hybrid bionanocomposite from cellulose nanowhisker and Mg/Al-CO3-LDHfor enhanced dye removal

Nanocellulose composites: synthesis, properties, and applications to wastewater treatment

New Insights into the Remediation of Water Pollutants using Nanobentonite Incorporated Nanocellulose Chitosan Based Aerogel

Cellulose–kaolin incorporated polymeric hydrogels and its application for dye removal: batch study and mechanism

Corn Husk‐Derived Carbon Fused with Iron Oxide as Adsorbent for Cationic Dyes

Development of a novel bionanocomposite of UiO-66/xanthan gum/alginate crosslinked by calcium chloride for azo dye removal: Insight into adsorption kinetics, isotherms, and thermodynamics

Exploring of Cellulose Nanocrystals from Lignocellulosic Sources as a Powerful Adsorbent for Wastewater Remediation

MXene—Reclaimed Cellulose Acetate Composites for Methylene Blue Removal Through Synergistic Adsorption and Photocatalysis

Facile Fabrication of Embedded g-C3N4/MoS2 Nano-Adsorbent for Removal of Persistent Rhodamine B Contaminant in Aqueous Solution

Current State and New Trends in the Use of Cellulose Nanomaterials for Wastewater Treatment