Abstract:There have been over 17 million COVID-19 infections worldwide up to July 31, 2020, but the exact transmission route remains a subject for debate. Virus load in different-sized respiratory droplets is the key to address the above question. Investigation on the droplet deposition characteristics during exhalation inside the respiratory tract will facilitate the understanding of their origin and importance in transmitting the respiratory infection. Based on a realistic respiratory model, this study utilized the computational fluid dynamic (CFD) simulation to investigate the deposition of droplets originating from infection sites like pharynx, larynx and trachea under three flow conditions, namely 30 L/min (representing the normal breathing condition), 60 L/min (speaking) and 180 L/min (coughing). The SST k-omega turbulence model integrated in ANSYS Fluent software was utilized to obtain the flow field inside the respiratory tract by solving the continuity and momentum equations, and the Lagrangian approach was used to calculate droplet motion and deposition with the discrete random walk model to account for the turbulence fluctuation effect. Evaporation of droplets was not considered inside the saturated respiratory tract. Droplet diameter, flow rate of the exhaling air, and complexity of the respiratory tract geometry are the most important factors in determining the deposition pattern of respiratory droplets. It is revealed that the largest droplet that originates from the joint of pharynx and larynx and is able to escape out of the respiratory tract is about 20 mu m (30 L/min) or 10 mu m (60-180 L/min) in diameter; the so-called cut-off sizes for vocal cord and trachea originated droplets are 7 mu m (30 L/min), 5 mu m (60 L/min) or 3 mu m (180 L/min). Larynx and joint of larynx and pharynx are the most important deposition sites due to their complexity in geometry and the existence of the laryngeal jet, whose velocity is up to 102 m/s during coughing and 32 m/s during speaking; the nasal cavity is also effective in trapping relatively small droplets as the airflow has a sudden change in direction before entering the oral cavity. Under the investigated speaking scenario (60 L/min), the escape rate of 1 mu m droplets is around 50%, and the maximum escape rates of 5 and 10 mu m droplets are respectively 13.1% and 1.3% (originating from the joint of pharynx and larynx). Although large droplets up to several hundred micrometers can be produced inside the oral cavity due to the atomization mechanism, they seldom carry pathogen. Thus, for COVID-19 patents in the early stage of infection who show upper respiratory symptoms, the cut-off size of virus-laden droplets released into the environment is about 20 mu m; with the shifting of infection to the lower respiratory tract in the later stage, the cut-off size decreases to 7 mu m. Respiratory droplets evaporate immediately after escaping into the indoor environments and shrink to about one third of their initial size, so airborne route is speculated to be important in the transmission of COVID-19. Further investigations considering realistic flow conditions together with droplet sampling experiments on human volunteers are necessary to confirm these cut-off sizes.

Numerical study of single-cough generated droplets inhalation and deposition in an airway under realistic cyclic breathing in a quiescent air condition

Deposition of Droplets from the Trachea or Bronchus in the Respiratory Tract During Exhalation: A Steady-State Numerical Investigation

Numerical Investigation on the Origin of Virus-Laden Droplets in the Respiratory Tract

Coupled discrete phase model and Eulerian wall film model for numerical simulation of respiratory droplet generation during coughing

Numerical Simulation of Inhaled Aerosol Particle Deposition Within 3d Realistic Human Upper Respiratory Tract

A quasi-realistic computational model development and flow field study of the human upper and central airways

Cloud and droplet dynamics during a human coughing event under fully mixed and unmixed room conditions

Numerical and Experimental Analysis of Drug Inhalation in Realistic Human Upper Airway Model

Direct numerical simulation of the turbulent flow generated during a violent expiratory event

CFD modeling of the transport of human respiratory droplets in an indoor environment

Numerical study on the deposition distribution and mechanism of inhaled drug particles in various regions of the realistic inhaler-airway model

Numerical study of the transport of droplets or particles generated by respiratory system indoors

Airborne spread of human coughing droplets with different postures and relative orientation in wards combined with peacetime and epidemic periods

Micron particle deposition in a tracheobronchial airway model under different breathing conditions

Computational transport, phase change and deposition analysis of inhaled multicomponent droplet–vapor mixtures in an idealized human upper lung model

Aerosol deposition and airflow dynamics in healthy and asthmatic human airways during inhalation

Droplet nuclei caustic formations in exhaled vortex rings

Numerical simulation on exhaled aerosol transmission based on realistic oral-nasal structures and temperature distribution

Predominance of Inhalation Route in Short-Range Transmission of Respiratory Viruses: Investigation Based on Computational Fluid Dynamics

Effect of airflow rate on droplet deposition of an impinging-jet inhaler in the human respiratory tract

Numerical Simulation of the Effect of Respiratory Cycle on Inhalable Particle Deposition in Alveolus