Abstract:Chemical dyes used in the textile industries are one of the major pollutants in water. Methylene blue (MB) is a commonly seen dye that creates hazardous health problems. In this article the photocatalytic degradation of MB by the nanocatalyst MoS 2 (Nano-MoS 2 ) and carbon dot (C Dots) incorporated MoS 2 (Nano-CD-MoS 2 ) is reported. The photocatalytic degradation of MB is analyzed based on the electron-hole recombination rate of the catalyst. Photoluminescence emission exhibited by the catalyst is used as a key indicator to probe the electron-hole recombination rate. Nano-MoS 2 was synthesized hydrothermally at 180 0 C for 8 h from ammonium tetra thiomolybdate (ATTM). C Dot was prepared following a green root from ash guard extract which later mixed with Nano-MoS 2 and kept in an autoclave at a temperature 140 °C for 4 h to get Nano-CD-MoS 2 . The photoluminescence (PL) and photocatalytic behavior of Nano-MoS 2 and Nano-CD-MoS 2 and their application for water splitting and water purification are reported. The incorporation of graphene and artificial C Dot into MoS 2 nanostructures are reported to increase the conductivity and active edge sites of MoS 2 that enhances the photocatalytic action. Since green C Dots are eco-friendly and easily synthesizable than artificial C Dots, as a novel study, this article investigated the influence of green C Dots on the PL and photocatalytic performance of nanosized MoS 2 . Nano-MoS 2 and Nano-CD-MoS 2 exhibited both upconversion and downconversion PL; accordingly the nanostructures were termed as amphi -luminescent. The amphi -luminescence property widens the photon absorption range and hence enhances the catalytic degradation of dyes. Nano-MoS 2 which exhibited lesser intensity of amphi -luminescence emission compared to Nano-CD-MoS 2 showed better results in degradation of MB. C Dots may bind with the valence band electrons of MoS 2 , resulting in the reduction of dangling bonds Dangling bonds can trap photo-induced excitons to hinder the rate of electron-hole recombination. So, fast electron-hole recombination occurs in Nano-CD-MoS 2 than Nano-MoS 2 . Fast electron-hole recombination supports radiative electron-hole recombination while suppresses the non-radiative energy transfer of electrons and causes high PL intensity. However, according to the energy level diagram, Nano-MoS 2 with minimal electron-hole recombination rate is more favorable for O 2 /O 2 – ,OH/ OH – andOH/H 2 O reactions that facilitate MB degradation. Photocatalytic activity of catalysts were confirmed by measuring the photocurrent from a simple custom-made two-electrode water photolysis cell where the nanocatalysts were dispersed in electrolyte. Lead and steel rods were used as electrodes. Multimeter was used to measure current. Nano-MoS 2 exhibited better performance with a maximum photocurrent of 141 μA. Influence of green C Dots in energy levels, PL and photocatalysis of MoS 2 and mechanisms of PL and degradation of MB are thoroughly investigated in this article.

Enhanced photocatalytic activity of plasmonic Au nanoparticles incorporated MoS$_2$ nanosheets for degradation of organic dyes

Plasmonic Au-MoS2 Nanohybrids Using Pulsed Laser-Induced Photolysis Synthesis for Enhanced Visible-Light Photocatalytic Dye Degradation

Enhanced visible-light photocatalytic activity of Fe3O4@MoS2@Au nanocomposites for methylene blue degradation through Plasmon-Induced charge transfer

Amphi-Luminescent MoS 2 nanostructure for photocatalytic splitting of water and removal of Methylene Blue

Optimization of CuAl2O4 Nanoparticles for Enhanced Photocatalytic Degradation of Organic Dyes Under UV and Visible Light

A monodisperse anionic silver nanoparticles colloid: Its selective adsorption and excellent plasmon-induced photodegradation of Methylene Blue

Enhanced dye degradation using 2H-MoS2 and 1T@2H-MoS2: A comparative study

Enhancing photodegradation of Methyl Orange by coupling piezo-phototronic effect and localized surface plasmon resonance

Facile fabrication of Au@CoFe2O4-ZnO hybrid plasmonic nanostructures with enhanced photocatalytic performance

Synergistic exploration of dye degradation and pulse photoresponse using MoS 2 nanosheets: Towards sustainable remediation and optoelectronic advancements

Enhanced Photocatalytic Degradation of Methyl Orange Using Nitrogen‐Functionalized MesoporousTiO2 Decorated with Au9 Nanoclusters

Enhanced photocatalytic degradation of organic pollutants by green-synthesized gold nanoparticles using polysaccharide for environmental remediation

Enhanced sunlight driven photocatalytic activity of In2S3 nanosheets functionalized MoS2 nanoflowers heterostructures

In-situ Fabrication of MoO3 Nanobelts Decorated with MoO2 Nanoparticles and Their Enhanced Photocatalytic Performance

Enhancement of visible light adsorption and photocatalytic degradation activity of organic dye by coating semiconducting TiO 2 shell on plasmonic Au particles

Gold Nanobipyramids Coated with Silver–Platinum Alloy Shells for Plasmonically Enhanced Photocatalytic Degradation of Methyl Orange

Understanding the Plasmonic Effect of Enhanced Photodegradation with Au Nanoparticle Decorated ZnO Nanosheet Arrays under Visible Light Irradiation

Plasmon-Enhanced Photocatalysis Using Gold Nanoparticles Encapsulated in Nanoscale Molybdenum Oxide Shell

Preparation of Au-MoS2 photocatalyst with a green synthesis method and its application in water contaminant degradation

Controllable Synthesis Of The Defect-Enriched Moo3-X Nanosheets As An Effective Visible-Light Photocatalyst For The Degradation Of Organic Dyes

Plasmonic Photocatalysts Based on Au Nanoparticles and WO3 for Visible Light-Induced Photocatalytic Activity