Abstract:The dynamic dashpot models are widely used in EDEM commercial software. However, most dashpot models suffer from a serious numerical issue in calculating the granular chain because the denominator of damping force includes the initial impact velocity. Moreover, the existing dynamic dashpot models extended from the original Hertz contact law overestimated the contact stiffness in the elastoplastic contact phase. These two reasons above result in most dynamic dashpot models confronting some issues in calculating the multiple collision of the granular chain. Therefore, this investigation aims to propose a new composite dynamic dashpot model for the dynamic simulation of granular matters. First, the entire contact process is divided into three different phases: elastic, elastoplastic, and full plastic phases. The Hertz contact stiffness is still used in the elastic contact phase when the contact comes into the elastoplastic or full plastic phase. Hertz contact stiffness in the dynamic dashpot model is replaced by linearizing the contact stiffness from the Ma-Liu (ML) model in each time step. Second, the whole contact behavior is treated as a linear mass-spring-damper model, and the damping factor is obtained by solving the single-degree-freedom underdamped vibration equation. The new dynamic dashpot model is proposed by combining the contact stiffnesses in different contact phases and corresponding damping factors, which not only removes the initial impact velocity from the denominator of damping force but also updates the contact stiffness based on the constitutive relation of the contact body when the contact comes into the elastoplastic or full plastic phase. Finally, a granular chain is treated as numerical examples to check the reasonability and effectiveness of the new dynamic dashpot model by comparing it to the experimental data. The simulation shows that the solitary waves obtained using the new dashpot model are more accurate than the dashpot model used in EDEM software.

Correction of the spring-dashpot-slider model

Three-equation linear spring-dashpot DEM model and the determination of contact parameters

Nonlinear wave in granular systems based on elastoplastic dashpot model

Energy Dissipation Analysis for Elastoplastic Contact and Dynamic Dashpot Models

Linear-frictional contact model for 3D discrete element simulations of granular systems

Development of a compliant dashpot model with nonlinear and linear behaviors for the contact of multibody systems

Using the discrete element method to develop collisional dissipation rate models that incorporate particle shape

2D Numerical Model for Studying Frictional Sliding

Development of a Collisional Dissipation Rate Model for Frictional Cylinders

A Regularized Contact Model with Asymmetric Damping and Dwell-Time Dependent Friction

A NOVEL DISCRETE ELEMENT ROLLING RESISTANCE MODEL BASED ON HYSTERESIS SPRING ENERGY DISSIPATION

A frictional spring and cohesive contact model for accurate simulation of contact forces in numerical manifold method

Coarse-grained model for spring friction study of micron-scale iron by smoothed particle hydrodynamics

Entanglements via Slip-Springs with Soft, Coarse-Grained Models for Systems Having Explicit Liquid-Vapor Interfaces

Elasto-frictional reduced model of a cyclically sheared container filled with particles

A Methodology for Modeling and Simulating Frictional Translational Clearance Joint in Multibody Systems Including a Flexible Slider Part

A Framework to Simulate Friction Stir Additive Manufacturing (FSAM) Using the Finite Element Method

Reexamination of Damping in Sliding Friction

Optimal Energy Dissipation in Sliding Friction Simulations

Living in the Multiverse

Application of fractional calculus methods to viscoelastic behaviours of solid propellants