Thermal cracking of oil under water pressure up to 900 bar at high thermal maturities. 1, gas compositions and carbon isotopes
Liujuan Xie,Yongge Sun,Clement N. Uguna,Youchuan Li,Colin E. Snape,Will Meredith
DOI: https://doi.org/10.1021/acs.energyfuels.5b02792
IF: 4.6541
2016-01-01
Energy & Fuels
Abstract:In this study, a C-9(+) fraction of saturate-rich Tertiary source rock-derived oil from the South China Sea basin was pyrolyzed in normal and supercritical water using a 25 mL vessel at a range of temperature from 350 to 425 degrees C for 24 h, to probe pressure effects up to 900 bar on gas yields and their stable carbon isotopic compositions during thermal cracking. Pressure generally retards oil cracking, as evidenced by reduced gas yields, but the trends depend upon the level of thermal evolution. In the early stages of cracking (350 and 373 degrees C, equivalent vitrinite reflectance of < similar to 1.1 % R-0), the suppression effect increases with pressure from 200 to 900 bar, but it is most marked between 200 and 470 bar. At the later stages in the wet gas window (390, 405, and 425 degrees C, equivalent vitrinite reflectance of >1.3% R-0), pressure still has a strong suppression effect from 200 to 470 bar, which then levels off or is reversed as the pressure is increased further to 750 and 900 bar. Interestingly, the stable carbon isotopic composition of the generated methane becomes enriched in C-13 as the pressure increases from 200 to 900 bar. A maximum fractionation effect of similar to 3 parts per thousand is observed over this pressure range. Due to pressure retardation, the isotopically heaviest methane signature does not coincide with the maximum gas yield, contrary to what might be expected. In contrast, pressure has little effect on ethane, propane, and butane carbon isotope ratios, which show a maximum variation of similar to 1 parts per thousand. The results suggest that the rates of methane-forming reactions affected by pressure control methane carbon isotope fractionation. Based on distinctive carbon isotope patterns of methane and wet gases from pressurized oil cracking, a conceptual model using "natural gas plot" is constructed to identify pressure effect on in situ oil cracking providing other factors excluded. The transition in going from dry conditions to normal and supercritical water does not have a significant effect on oil-cracking reactions as evidenced by gold bag hydrous and anhydrous pyrolysis results at the same temperatures as used in the pressure vessel.