Abstract:The flow condensation heat transfer coefficient of R134a inside two helical micro-fin tubes with outer diameter of 6.35 mm and helical angles of 18o and 28o respectively were experimentally studied at a high mass flux ranging from 500 to 1100 kg m−2 s−1. The condensation temperatures are 35°C, 40°C and 45°C, and the vapor qualities ranges from 0.95 to 1.00 at the inlet section and from 0.00 to 0.05 at the outlet section. Experimental results show that there are annular and intermittent flow regimes inside the tube under experimental conditions, the ratio of annular flow region to the total heat transfer region is about 70%. The liquid film flow changes from rotational flow to coexistence of rotational and horizontal flows when the vapor quality is 0.475±0.08, 0.486±0.06 and 0.521±0.05, respectively and the corresponding saturation temperature is 35°C, 40°C and 45°C. Based on the experimental data, the heat transfer coefficient increases with increasing mass flux and fin helical angle, and with decreasing saturation temperature and Reynolds number of cooling water. In addition, the heat transfer coefficient of annular flow is greater than that of intermittent flow, in other words, the heat transfer coefficient increases with increasing vapor quality. The heat transfer coefficient obtained at high mass flux was compared with the calculated data of some published correlations used at low mass flux. It was found that most correlations underestimate the experimental heat transfer coefficient inside the micro-fin tube, and these prediction deviation increases with increasing mass flux and fin helical angle. By introducing some dimensionless numbers as well as considering the flow mechanism of liquid film inside the tube, two heat transfer coefficient correlations were proposed based on the experimental data. The ratio of liquid film thickness to fin height was used to characterize whether the liquid film flow is rotational flow or coexistence of rotational and horizontal flows in the proposed correlation, which shows a better prediction accuracy with a mean deviation of less than 7.3%.

Development of a compact laminar flow heat exchanger with stainless steel micro-tubes

Design of a Sub-Atmospheric Heat Exchanger for a Hundred-Watt 2 K System.

Development and Validation of Helical-Coil-in-fluted-tube Gas Cooler for CO2 Heat Pump Water Heaters

Heat transfer of laminar oscillating flow in finned heat exchanger of pulse tube refrigerator

Numerical and Experimental Study on a Tube-in-tube Heat Exchanger Working at Liquid-Hydrogen Temperature with a Large Temperature Span

Thermal Design Of Heat Exchanger With Fins Inside And Outside Tubes

Development of Small-diameter Tube Heat Exchanger : Circuit Design and Performance Simulation

Design and performance of a novel compact high-effectiveness transparent-wall counter-flow heat exchanger fabricated using additive manufacturing

Study on a Miniature Mixed-gases Joule-Thomson Cooler Driven by an Oil-lubricated Mini-compressor for 120 K Temperature Ranges

Design and Optimization of a Helix Finned Tube Heat Exchanger for 2 K Superfluid Helium Vertical Test Stand

Experimental Study of Condensation Heat Transfer of R134a Inside the Micro-Fin Tubes at High Mass Flux

Experimental Study on Flow and Heat Transfer of High-Pressure Helium Flow in Compact Helical Tube Heat Exchanger in HTGR

Numerical Simulations of Sub-Atmospheric J-T Heat Exchanger for Superfluid Helium Cryogenic System

Low temperature thermal resistance for a new design of silver sinter heat exchanger

Compact Metallic High-Temperature Heat Exchangers

Development of Small-diameter Tube Heat Exchanger : Fin Design and Performance Research

Practical design of a heat exchanger for dilution refrigeration 1

Design of a compact mesh-based high-effectiveness counter-flow heat exchanger and its integration in remote cooling systems

Fin Design for an Evaporator with Small Diameter Microgroove Tubes

Improving the compact heat exchangers with profiled tubes for marine power plants

Numerical study of heat transfer characteristics of intermittent flow cold storage surface heat exchanger