Abstract:Operational Modal Analysis (OMA) identifies modal properties of mechanical structures from vibration data collected from a few sensors under operation conditions. These methods are widely used to monitor civil engineering structures that are modeled as time-invariant systems. However, when dealing with wind turbines and rotating machines, many dedicated OMA techniques were developed to deal with the time-periodic behavior. Existing methods pre-process the data to adapt them to classical identification techniques. Yet, these methods present limitations as either requiring a high number of measured rotation periods, assuming the assumption of an isotropic rotor (i.e. undamaged), or the knowledge of the rotational speed. This work proposes to lift these difficulties by proving that the application of the classical system identification methods can produce meaningful estimates for anisotropy monitoring. This observation is based on directly approximating the time-periodic dynamic behavior of the wind turbine as a properly defined time-invariant system under periodic inputs. It results in the possibility of using classical identification methods without modification to retrieve the system matrices of the approximated time-invariant system. This approach does not require knowing the rotor speed, requiring relatively fewer measurements and it is not restricted to isotropic rotors. The identified modes can be used reliably for the monitoring of operating wind turbines and more especially for fault detection, at the expense of losing a part of the complete description of the periodic system. The resulting anisotropy monitoring approach and its capacities are illustrated in two cases. Firstly, on an academic model of a wind turbine and then on an aero-servo-elastic numerical model of a rotating 10 MW wind turbine to demonstrate the ability of the method to deal with realistic and representative data. It is shown for the latest case, from sensors located on the blades of the wind turbine, the approach is able to identify correctly the system properties (frequencies and mode shapes) and is also able to detect efficiently a fault on a blade.

Damping Identification of an Operational Offshore Wind Turbine using Kalman filter-based Subspace Identification

Damping Identification of an Operational Offshore Wind Turbine using Enhanced Kalman filter-based Subspace Identification

Analysis of Vibration Monitoring Data of an Onshore Wind Turbine under Different Operational Conditions

Modal Parameter Identification of Jacket-Type Offshore Wind Turbines Under Operating Conditions

Identification of support structure damping of a full scale offshore wind turbine in normal operation

Structural health monitoring of offshore wind turbines using automated operational modal analysis

Mitigation of Side-to-side Vibration of a 10MW Monopile Offshore Wind Turbine under Misaligned Wind and Wave Conditions by an Active Torque Control

Data driven damping separation method for the Mega-offshore wind turbine tower

OC6 Phase I: Investigating the Underprediction of Low-Frequency Hydrodynamic Loads and Responses of a Floating Wind Turbine

Fully Automated Operational Modal Analysis using multi-stage clustering

Monitoring of Subsynchronous Oscillation in a Series‐compensated Wind Power System Using an Adaptive Extended Kalman Filter

A modal decomposition and expansion approach for prediction of dynamic responses on a monopile offshore wind turbine using a limited number of vibration sensors

Multi-objective optimization of a negative stiffness vibration control system for offshore wind turbines

Measurement-Driven Source Tracing of Torsional Subsynchronous Oscillations Caused by Open-Loop Modal Resonance

Vibration source identification of offshore wind turbine structure based on optimized spectral kurtosis and ensemble empirical mode decomposition

Optimized design of multiple tuned mass dampers for vibration control of offshore wind turbines

Edinburgh Research Explorer Operational modal analysis for scour detection in mono-pile offshore wind turbines

Analytical study on the aerodynamic and hydrodynamic damping of the platform in an operating spar-type floating offshore wind turbine

Linear time periodic system approximation based on Floquet and Fourier transformations for operational modal analysis and damage detection of wind turbine

The impact of passive tuned mass dampers and wind–wave misalignment on offshore wind turbine loads

Offshore Wind Turbine Load Reduction Employing Optimal Passive Tuned Mass Damping Systems