Abstract:The ejector refrigeration cycle (ERC) is often used as the sub-cycle of power and cooling cogeneration systems due to its advantages of simple structure design, few moving parts, less system investment, good stability and reliable operation. Considering the potential of organic Rankine cycle (ORC) in the utilization of low-grade heat, and the advantages of simple structure and many choices for working fluid, a novel power and cooling cogeneration system was designed, based on dual-pressure evaporation ORC (DORC) and ERC. In this system, a common condenser was used by DORC and ERC, and a part of working fluid separated from low-pressure steam generator outlet in DORC was used as the primary flow of ejector to drive ERC. A mathematical model for calculating the thermodynamic and thermoeconomic performances of the system was established. Sensitivity analysis was performed to determine the key parameters of the system, the results showed that the low-pressure evaporation temperature (TLPSG,out), high-pressure evaporation temperature (THP,E), vapor fraction of the low-pressure steam generator outlet (xLPSG,out) and working fluid mass flow ratio of high-pressure stage to low-pressure stage (k) were the four key parameters of the system. Parametric analysis showed that higher TLPSG,out and lower xLPSG,out were beneficial to increase the cooling output and thermal efficiency, while higher THP,E and larger k were helpful to increase the net power output and exergy efficiency. The net power output and exergy efficiency can be optimized by TLPSG,out and xLPSG,out. Using genetic algorithm (GA), multi-objective function optimization was carried out with THP,E, TLPSG,out, xLPSG,out and k as the decision variables. Moreover, the system's adaptability for working fluids R245fa, R236ea, R600, R600a, R601 and R601a was investigated. According to the optimization results, R236ea was the most suitable working fluid. When THP,E was 402.43K, TLPSG,out was 392.42K, xLPSG,out was 0.357 and k was 0.321, the calculated net power output , cooling output, thermal efficiency, exergy efficiency and total cost of unit exergy product (SUCP) were 273.00kW, 121.80kW, 14.52%, 44.03% and 42.62$/MWh, respectively. Exergy analysis was conducted using R236ea as working fluid. The results showed that the two steam generators and condenser were the main components responsible for most of the exergy destruction of the system in both basic case and optimized case. Compared to the basic case, the exergy destruction of the steam generators decreased by about 32.3%, and the total exergy destruction of the system decreased by about 5.0% in optimized case.

Thermodynamic Analysis of Integrated Gasification Combined Cycle Integrated with Organic Rankine Cycle for Waste Heat Utilization

Waste heat utilization using organic rankine cycle from a pressurized pulverized combined cycle power plant

Thermoeconomic analysis of organic Rankine cycle with different working fluids for waste heat recovery from a coal-based thermal power plant

Analysis of a 1 Kw Organic Rankine Cycle Using a Scroll Expander for Engine Coolant and Exhaust Heat Recovery

Thermo-Economic Analysis of Organic Rankine Cycle with Different Working Fluids for Waste Heat Recovery from Coal-based Power Plant

Thermoeconomic analysis of a novel cogeneration system for cascade recovery of waste heat from exhaust flue gases

Thermodynamic Investigation of an Integrated Solar Combined Cycle with an ORC System

Thermodynamic and Economic Analysis of Oxy-Fuel-Integrated Coal Partial Gasification Combined Cycle

Direct integration of an organic Rankine cycle into an internal combustion engine cooling system for comprehensive and simplified waste heat recovery

Energy, exergy, economic, and environment (4E) assessment of trans-critical organic Rankine cycle for combined heating and power in wastewater treatment plant

Waste heat from a biomass fueled gas turbine for power generation via an ORC or compressor inlet cooling via an absorption refrigeration cycle: A thermoeconomic comparison

Thermodynamic and exergoeconomic analysis of combined supercritical CO2 cycle and organic Rankine cycle using CO2-based binary mixtures for gas turbine waste heat recovery

A 3E analysis of a multi‐power generation system employing CO2, LNG, and Organic Rankine cycles

Exergoeconomic Analysis and Optimization of a Biomass Integrated Gasification Combined Cycle Based on Externally Fired Gas Turbine, Steam Rankine Cycle, Organic Rankine Cycle, and Absorption Refrigeration Cycle

Analysis of Kalina cycle for recovering waste heat from flue gas exhaust in pressurised pulverised combined cycle

Thermo-economic analyses on a new conceptual system of waste heat recovery integrated with an S-CO2 cycle for coal-fired power plants

Thermodynamic and thermoeconomic performance analyses and optimization of a novel power and cooling cogeneration system fueled by low-grade waste heat

Thermo-Economic Analysis of Solar-Powered Trigeneration System With Integrated Ejector-Absorption Recompression and Modified Organic Rankine Cycle

Performance and Sustainability Analysis of an Organic Rankine Cycle System in Subcritical and Supercritical Conditions for Waste Heat Recovery

Energetic and Exergetic Analyses of Biomass Derived Syngas for Triple Cycle Power Generation

Techno-economic analysis on a new conceptual design of waste heat recovery for boiler exhaust flue gas of coal-fired power plants