Abstract:CONSPECTUS: The conversion of solar energy to chemicals and the storage of this energy is one of the most promising routes to realizing a "carbon zero" society, for which particulate photocatalytic water splitting to produce hydrogen has been considered to be a clean potential route. For this purpose, many d(0) and d(10) metal-based nitrogen-incorporated oxide (including nitrogen-doped oxide and oxynitride) semiconductor photocatalysts have been developed as good candidates to harvest major visible regions of solar light and to exhibit suitable energy levels to drive water splitting. Compared to the oxide-type photocatalysts, valence bands of the nitrogen-incorporated oxide can be upshifted in consideration of the lower electronegativity of nitrogen atoms concerning the oxygen atoms. However, a high-temperature nitridation process was needed to introduce nitrogen atoms into the metal oxide lattice. Because of the poor charge balance of the N3- substitution for O2- and the strong reducing effect of the active nitrogen species at high temperature, the nitriding process tends to introduce both anionic vacancy defects as well as low-valent metal ion defects. In addition, the crystal size of (oxy)nitrides synthesized through high-temperature nitridation is generally large, and there is a lack of an effective charge-separation driving force within the bulk of the (oxy)nitrides. Because of the scarcity of surface catalytic sites, the photocatalytic activity of the (oxy)nitrides is rather low. Recently, our group has been devoted to addressing the above key challenges, especially for the d(0)-metal-based (oxy)nitrides. The new preparation routes and/or methods were carried out to enhance the nitration kinetics for the synthesis of (oxy)nitrides with low-defect concentrations and further fabricate some novel metal (oxy)nitrides. The doping strategies were developed to suppress the generation of low-valent metal ion defects. A one-pot nitridation strategy was developed to construct the type II heterostructures of two metal oxynitrides to enhance their charge separation, and a strategy for the surface modification of metal oxynitrides with inert metal oxides was developed to promote the surface hydrophilicity and the cocatalyst dispersion. In addition, an intimate and strengthened interface between the cocatalyst and the metal oxynitride photocatalyst was achieved by a sequential cocatalyst decoration method, and it was demonstrated that the strengthened interface is beneficial to enhancing the surface charge separation efficiency. Benefitting from these methods and strategies, some novel visible-light-responsive materials have been exploited for promising water splitting, and remarkably improved water splitting performances have been achieved on some typical d(0)-metal-based (oxy)nitrides regardless of H-2/O-2-evolving half-reactions and Z-scheme overall water splitting (Z-OWS) reactions. In this Account, we will give a concise summary of these methods and strategies, and the prospects of nitrogen-incorporated oxide photocatalysts for potential water splitting will be examined.

Molten Salt Modulation of Potassium-Nitrogen-Carbon for the Breaking Kinetics Bottleneck of Photocatalytic Overall Water Splitting and Environmental Impact Reduction

Potassium Molten Salt-Mediated In Situ Structural Reconstruction of a Carbon Nitride Photocatalyst.

Molten Salt-Lithium Process Induced Controllable Surface Defects in Titanium Oxide for Efficient Photocatalysis

Modulation of Excitonic Confinement of TiO2 in Molten Salts for Overall CO2 Photoreduction

Salt-Mediated Structural Transformation in Carbon Nitride: From Regulated Atomic Configurations to Enhanced Photocatalysis

Molten salt-induced vertical CoP/Co nanosheets array coupled with carbon for efficient water splitting

Photocatalytic overall water splitting by conjugated semiconductors with crystalline poly(triazine imide) frameworks.

Modulation of Lewis acidic-basic sites for efficient photocatalytic H2O2 production over potassium intercalated tri-s-triazine materials

Novel BiOBr/Bi2S3 high-low junction prepared by molten salt method for boosting photocatalytic degradation and H2O2 production

"The Easier the Better" Preparation of Efficient Photocatalysts-Metastable Poly(heptazine imide) Salts

Non‐Lignin Substrate Constructing the Gas‐Solid Interface For Enhancing The Photothermal Catalytic Water Vapor Splitting

Harmonious K-I-O co-modification of g-C3N4 for improved charge separation and photocatalysis

Unraveling the Kinetics of Photocatalytic Water Oxidation on WO 3 .

Synthesis of Composite Titanate Photocatalyst via Molten Salt Processing and Its Enhanced Photocatalytic Properties

Molten Salts-Driven Discovery of a Polar Mixed-Anion 3D Framework at the Nanoscale: Zn4 Si2 O7 Cl2 , Charge Transport and Photoelectrocatalytic Water Splitting

Exploring Cr and Molten Salt Interfacial Interaction for Molten Salt Applications

Bubble-water/catalyst triphase interface microenvironment accelerates photocatalytic OER via optimizing semi-hydrophobic OH radical

Strategies and Methods of Modulating Nitrogen-Incorporated Oxide Photocatalysts for Promoted Water Splitting

A recyclable molten-salt synthesis of B and K co-doped g-C3N4 for photocatalysis of overall water vapor splitting

Synergistic Oxygen Substitution and Heterostructure Construction in Polymeric Semiconductors for Efficient Water Splitting

Acceleration of Thermal Decomposition of Molten Nitrates by Cr in Steel and Promotion of This Effect by Halogens