Abstract:This article describes a much simplified, Digital and analog mixed architecture that support general S-band transponder operation. The mass is reduced to under 1.4kg (including TCXO), and the dimension is about 170 *70*100mm. The power consumption is less than 11W measured in the side of 28V input with 1W SSPA transmitter output. The mass cut down is benefit mainly from the progress of digital design techniques and the improvement of the FPGA technologies. The designer implements the IF command and tracking demodulation by a 3 million system gates FPGA. Furthermore, the device is employed with tri-mode-redundancy. The algorithm of the main carrier tracking is based on phase lock loop, the command demodulation is based on Costas loop for sub carrier tracking and DTTL loop for bit synchronization. The carrier acquisition threshold is under -128 dBm with PM/BPSK demodulation losses < 1dB. The dynamic range is from -128 dBm to -55 dBm. The second technique that decreases the complexity is the structure of RF front-side. We use a small size saturated amplifier replacing the AGC amplifier, the saturation amplifier depresses the mostly of the signal dynamic and DSP deal with the dynamic left. We select a low power A/D converter with working frequency under 3Msps in under-sampling mode; however, the IF frequency is about 9.3MHz that can diminish the order of RF front-side down converter and the difficulties of analog band pass filter design. For the standard of the USB transmitter is only support modulation type: BPSK/PM, so we build a RF-IF close loop transmitter architecture that eliminate the components used in up converter architecture, the saved mixers and band pass filters extremely reduce the amount and the volume of PCB. Moreover, we creatively put the coherent forwarding signal generator and the Frequency-Phase Detector together in FPGA. The digital phase noise or jitter is wonderfully filtered by a well-designed analog low pass loop filter. To conclude, there is not any DAC or RF-filter in transponder's transmitter loop. The other advantage is that we can adjust the modulation index easily by digital parameter. The transponder developed by NSSC is under flight verification.

Pseudo‐Random Code Generator Design for Satellite Transponder of 5G Wireless Networks

Implementation of a New S-Band Micro-Transponder Based on Software Defined Radio

Satellite Onboard Transmitter Design With Spread Spectrum MIMO Antenna for 5G Wireless Networks

Design of Modulator and Demodulator for Pico-Satellite Software TT&C Transponder

An Effective SNR Promotion Method for Mini-Satellite Pseudo-Code Range Measurement

A new implementation of S-band TT&C transponder for micro-satellites

Design and Derivation of the Dual Transponder Carrier Ranging System

Design and Implementation of Micro-Satellite Receiver Using CORDIC Algorithm

A New Receiver Structure of TT&C Transponder for Pico-Satellite

Design of S-Band Tt&C Transponder for Pico-Satellites

Design and Testing of a Digital Satellite Dual-module TDRSS/USB Transponder

A Practical Slotted Quasi-Synchronous CDMA Access System for LEO Micro-Satellite Short Message Transmission.

A creative architecture for mass-sensitive transponder

Maximization of Link Capacity by Joint Power and Spectrum Allocation for Smart Satellite Transponder.

Performance Analysis of a 5G Transceiver Implementation for Remote Areas Scenarios

Design and Implementation of Dual-Mode Satellite TT&C Transponder Baseband System with COTS Components

Two-Step Random Access Using Spatial Grouping and User Paring in Satellite Communication Systems

A 9mw 6-9Ghz 2.5gb/s Proximity Transmitter with Combined OOK/BPSK Modulation for Low Power Mobile Connectivity.

Photonic Pre-Coding for MIMO System in Satellite-Terrestrial Communication

CCSDS 131.2-B-1 Transmitter Design on FPGA with Adaptive Coding and Modulation Schemes for Satellite Communications

A Novel Forward-Link Multiplexed Scheme in Satellite-Based Internet of Things