Performance and near-wake characterization of a tidal current turbine in elevated levels of free stream turbulence

Ashwin Vinod,Arindam Banerjee
DOI: https://doi.org/10.1016/j.apenergy.2019.113639
IF: 11.2
2019-11-01
Applied Energy
Abstract:<p>Tidal turbines are deployed in sites which have elevated levels of free stream turbulence (FST). Accounting for elevated FST on their operation become vital from a design standpoint. Detailed experimental measurements of the dynamic near-wake of a tidal turbine model in elevated FST environments is presented; an active grid turbulence generator developed by our group was used to seed in the elevated FST and evaluate the influence of turbulence intensity (<em>T</em><sub>i</sub>) and inflow integral length scale (<em>L</em>) on the near-wake of the turbine. Three inflow conditions are tested: a quasi-laminar flow with <em>Ti</em> ~ 2.2% and two elevated <em>Ti</em> (~12–14%) cases, one with <em>L</em> ~ 0.4<em>D</em> (<em>D</em> is the turbine diameter) and the other where <em>L</em> ~ <em>D</em>. Elevated <em>Ti</em> cases were found to increase the standard deviation of rotor torque by 4.5 times the value in quasi-laminar flow. Energy recovery was also found to be accelerated; at <em>X</em>/<em>D</em> = 4, the percentage of inflow energy recovered was 37% and was twice the corresponding value in quasi-laminar flow. Elevated FST was observed to disrupt the rotational character of the wake; the drop in swirl number ranged between 12% at <em>X</em>/<em>D</em> = 0.5 and 71% at <em>X</em>/<em>D</em> = 4. Elevated <em>Ti</em> also resulted in <em>L</em> that were considerably larger (&gt;2 times) than the quasi-laminar flow case. An increase in inflow integral length scale (from 0.4<em>D</em> to <em>D</em>) was observed to result in enhanced wake <em>Ti</em>, wake structures and anisotropy; however, no noticeable influence was found on the rate of wake recovery.</p>
energy & fuels,engineering, chemical
What problem does this paper attempt to address?