Abstract:Carbon dioxide is a typical kind of greenhouse gases, and the oil and gas field recovery ratio could be significantly improved by injecting it into the formation. The main goal is to increase the recovery ratio in the early stage of studying gas injection miscible flooding. With the advancement of the “carbon neutral” strategy in China, the application of CO2 miscible flooding technology, which aims to enhance the oil recovery ratio in Chinese oilfields, has been further expanded. The development concept needs to change from simply improving the recovery ratio to improving both the recovery ratio and the CO2 storage ratio. In the current CO2 flooding research, people mainly focus on the improvement of the recovery factor, and less attention is paid to the underground storage of CO2. In order to further study the relationship between the displacement efficiency of CO2 and the storage situation, this paper innovatively combines the storage ratio and storage amount of CO2 with the recovery factor. A number of parameters under different injection methods in the study area were calculated, providing a new research angle for the study of CO2 displacement. Take Chang 8 reservoir in Block H of Ordos Basin as an example. Firstly, the minimum miscibility pressure (MMP) of CO2 at formation temperature was measured by the slim tube experiment according to the reservoir pressure status to judge the CO2 flooding status in the study area. Then, the numerical simulation model of the study area was established, and the historical fitting was completed according to the existing CO2 flooding test wells. The reservoir numerical simulation is used to study the recovery ratio and CO2 storage ratio under different CO2 miscible flooding, including different injection rates, injection sequences, and bottom hole pressures. The results show that the MMP of CO2 in the study area is between 12.65 and 14.80 MPa, which means the CO2 flooding state in this area is miscible flooding with high oil displacement efficiency. The CO2 storage ratio at 5–40 t/d CO2 injection rate is between 54.02% and 64.38% after 20 years, and the CO2 storage ratio is larger when the gas injection rate is 10 t/d. In combination with CO2 storage capacity and the oil recovery factor, it is recommended that the gas injection rate of a single well in the study area is 20–30 t/d. The CO2 storage ratio after 20 years under different gas injection sequences is 57.69%–61.27%. It is suggested that the study area should be injected with water and gas alternately after 2 years of gas injection. When continuous gas injection is used, the CO2 storage ratio under different production well bottom hole pressures is between 54.95% and 59.82%. It is recommended that the bottom hole flow pressure in the study area be maintained at between 9 and 10 MPa. The results show that the main factor that affects the annual CO2 storage ratio in the study area is the CO2 injection rate. Gas injection rate, injection sequence, and bottom hole pressure of production wells will all have an impact on the overall storage ratio. And alternate water and gas injection is quite significant. From the perspective of storage ratio, the optimal CO2 miscible flooding injection method has been optimized for the study area, which provides a reference for the implementation of CO2 underground storage technology in mines.

CO 2 storage capacity estimation by considering CO 2 Dissolution: A case study in a depleted gas Reservoir, China

Diagenetic Differences Caused by Gas Charging with Different Compositions in the XF13 Block of the Yinggehai Basin, South China Sea

Stability analysis of gas-water interface using carbon dioxide as cushion gas for gas storage in low permeability gas reservoir

A two-phase, multi-component model for efficient CO2 storage and enhanced gas recovery in low permeability reservoirs

Assessment of CO 2 storage potential in high water-cut fractured volcanic gas reservoirs—Case study of China's SN gas field

An analytical method for evaluating the underground hydrogen storage capacity in depleted gas reservoirs using CO 2 as cushion gas

Estimation of Formation Thermal Properties Distribution from Temperature in CO 2 Storage Wells

Stability Analysis of Multi-Well Gas Injection for Storing Co2 in Underground Aquifer

An Integrated Multi-Scale Model for CO2 Transport and Storage in Shale Reservoirs

Numerical Modelling of CO2 Injection and Storage in Low Porosity and Low Permeability Saline Aquifers: A Design for the Permian Shiqianfeng Formation in the Yulin Area, Ordos Basin

System and multi-physics coupling model of liquid-CO 2 injection on CO 2 storage with enhanced gas recovery (CSEGR) framework

Thermodynamic Properties of a Gas–Liquid–Solid System during the CO2 Geological Storage and Utilization Process: A Review

Numerical investigation of the influence of vertical permeability heterogeneity in stratified formation and of injection/production well perforation placement on CO2 geological storage with enhanced CH4 recovery

Capacity expansion analysis of UGSs rebuilt from low-permeability fractured gas reservoirs with CO2 as cushion gas

Numerical simulation and laboratory experiments of CO2 sequestration and being as cushion gas in underground natural gas storage reservoirs

Modeling of CO2 transport and pressure buildup in reservoirs during CO2 storage in saline aquifers: a case in Dongying Depression in China

Experimental and modeling study of CO2 solubility in formation brines at in-situ conditions

A Study on the Dissolution Behavior of Typical Minerals in Continental Deposited Reservoirs during CO2 Geological Storage

Feasibility Analyses and Prospects of CO2 Geological Storage by Using Abandoned Shale Gas Wells in the Sichuan Basin, China

Storage Ratio of CO2 Miscible Flooding in Chang 8 Reservoir of H Block in Ordos Basin under Different Injection Methods

Safety Analysis of Geothermal Water Recharge Coupled with CO2 Geological Storage System