Abstract:The eddy-covariance method is the primary way of measuring turbulent fluxes directly. Many investigators have found that these flux measurements often do not satisfy a fundamental criterion-closure of the surface energy balance. This study investigates to what extent the eddy-covariance measurement technology can be made responsible for this deficiency, in particular the effects of instrumentation or of the post-field data processing. Therefore, current eddy-covariance sensors and several post-field data processing methods were compared. The differences in methodology resulted in deviations of 10% for the sensible heat flux and of 15% for the latent heat flux for an averaging time of 30 min. These disparities were mostly due to different sensor separation corrections and a linear detrending of the data. The impact of different instrumentation on the resulting heat flux estimates was significantly higher. Large deviations from the reference system of up to 50% were found for some sensor combinations. However, very good measurement quality was found for a CSAT3 sonic together with a KH20 krypton hygrometer and also for a UW sonic together with a KH20. If these systems are well calibrated and maintained, an accuracy of better than 5% can be achieved for 30-min values of sensible and latent heat flux measurements. The results from the sonic anemometers Gill Solent-HS, ATI-K, Metek USA-1, and R.M. Young 81000 showed more or less larger deviations from the reference system. The LI-COR LI-7500 open-path H2O/CO2 gas analyser in the test was one of the first serial numbers of this sensor type and had technical problems regarding direct solar radiation sensitivity and signal delay. These problems are known by the manufacturer and improvements of the sensor have since been made.

Uncertainties in temperature statistics and fluxes determined by sonic anemometers due to wind-induced vibrations of mounting arms

Uncertainties in temperature statistics and fluxes determined by sonic anemometer due to wind-induced vibrations of mounting arms

Uncertainties in Turbulent Statistics and Fluxes of CO2 Associated with Density Effect Corrections

An Alternative Approach for CO2 Flux Correction Caused by Heat and Water Vapour Transfer

Evaluation of Probe-Induced Flow Distortion of Campbell CSAT3 Sonic Anemometers by Numerical Simulation

Correction of a Non-orthogonal, Three-Component Sonic Anemometer for Flow Distortion by Transducer Shadowing

The Energy Balance Experiment EBEX-2000. Part II: Intercomparison of Eddy-Covariance Sensors and Post-Field Data Processing Methods

Cutoff Time Scale of Eddy Covariance Method for Measuring Air-Sea Momentum Flux

A Motion Correction on Direct Estimations of Air-Sea Fluxes from a Buoy

Biases in wind speed measurements due to anemometer changes

Turbulent Variance Characteristics of Temperature and Humidity over a Non-Uniform Land Surface for an Agricultural Ecosystem in China

Data Management Technique for Eddy-Covariance Calculation of the Air-Sea Fluxes

Uncertainty Analysis of Eddy Flux Measurements in Typical Ecosystems of ChinaFLUX

Consequences of Incomplete Surface Energy Balance Closure for CO2 Fluxes from Open-Path CO2/H2O Infrared Gas Analysers

New Equations for Sonic Temperature Variance and Buoyancy Heat Flux with an Omnidirectional Sonic Anemometer

Re-estimation of the vertical sensible heat flux by determining the environmental temperature on a single-point tower measurement

Assessing the Accuracy of Eddy‐Covariance Measurement at Different Source Emission Scenarios

Evaluating Anemometer Drift: A Statistical Approach to Correct Biases in Wind Speed Measurement

Enlarged Nonclosure of Surface Energy Balance with Increasing Atmospheric Instabilities Linked to Changes in Coherent Structures

The Underestimation of the Turbulent Fluxes in Eddy Correlation Techniques

Uncertainty of CYGNSS-Derived Heat Flux Variations at Diurnal to Seasonal Time Scales over the Tropical Oceans