Abstract:The effectiveness of USEPA-registered algaecides for managing algae in lakes and reservoirs has been extensively evaluated in laboratory studies, mesocosm studies and in situ treatment. However, the use of these algaecides in marine environments for the management of dinoflagellates and associated toxins remains largely unknown. Karenia brevis is a toxic dinoflagellate that causes red tides in the Gulf of Mexico. In this study, we investigated the efficacy of six USEPA-registered algaecides, three copper-based and three peroxide-based, on treating toxic K. brevis with a natural bloom density (1.79 x 107 cells/L). Our results indicate that the application of as low as 0.31-0.34 mg Cu/L led to a significant decrease of K. brevis cells within 24 h after treatment, while peroxide-based algaecides required a relatively higher concentration for the effective removal of K. brevis cells (4.89-7.08 mg H2O2/L), but still lower than maximum label rate. Total brevetoxin levels 72 h after treatment revealed that 1.00 mg Cu/L for Algimycin (R) PWF, 6.48 mg H2O2/L for PAK (R) 27 and 7.08 mg H2O2/L for Oxi-mycin (R) P5 had the greatest impact on decreasing toxin levels. The correlation analysis showed that brevetoxin reduction rate was significantly positively related with the peroxide-based algaecide exposure concentration, which is caused by the oxidation of hydroxyl radicals produced by hydrogen peroxide. The degradation dynamics of the three peroxide-based algaecides revealed that salinity, microorganisms and organic matter (>= 0.2 mu m) impact the stability of hydrogen peroxide, and Oximycin (R) P5 showed the highest stability among tested peroxide-based algaecides with a degradation rate of 0.467 mg/d in natural seawater. Hence, our laboratory work provided new insights into potential emergency treatment methods for immediate mitigation of K. brevis and brevetoxins. More work on the fate and persistence of algaecide active ingredients and phycotoxins, effects of site characteristics, and pilot studies on marine non-targets are still needed before safe application of this method for HABs in marine systems.

Development of a Potentially New Algaecide for Controlling Harmful Cyanobacteria Blooms Which is Ecologically Safe and Selective

An innovative strategy to control Microcystis growth using tea polyphenols sustained-release particles: preparation, characterization, and inhibition mechanism

Improved Cyanobacteria Removal From Harmful Algae Blooms By Two-Cycle, Low-Frequency, Low-Density, And Short-Duration Ultrasonic Radiation

Micron-confined Microcapturer-Triggered Fenton As Efficient and Environmentally-Friendly Method for Simultaneously Capturing Bloom-Forming Cyanobacteria, Inhibiting Cell-Regrowth and Degrading Microcystins

Low-frequency ultrasound assisted contact-electro-catalysis for efficient inactivation of Microcystis aeruginosa

Continuous-release Beads of Natural Allelochemicals for the Long-Term Control of Cyanobacterial Growth: Preparation, Release Dynamics and Inhibitory Effects.

Controlling toxic Microcystis blooms: The power of a novel microalgal predator Poteriospumella lacustris in water safety improvement

Treatment of the Red Tide Dinoflagellate Karenia Brevis and Brevetoxins Using USEPA-registered Algaecides.

Harmful Cyanobacterial Blooms (HCBs): innovative green bioremediation process based on anti-cyanobacteria bioactive natural products

Release of algal organic matter from cyanobacteria following application of USEPA-registered chemical algaecides

Recent Advances in the Research on the Anticyanobacterial Effects and Biodegradation Mechanisms of Microcystis aeruginosa with Microorganisms

Oxidative stress of Microcystis aeruginosa induced by algicidal bacterium Stenotrophomonas sp. KT48

A novel algicidal bacteria isolated from native snail lived in Taihu Lake against algal blooms: identification, degradation kinetic, and algicidal mechanism

Aquatic environmental safety assessment and inhibition mechanism of chemicals for targeting Microcystis aeruginosa

Unleashing the Power of Acetylacetone: Effective Control of Harmful Cyanobacterial Blooms with Ecological Safety.

Designing a cercosporin-bioinspired bifunctional algicide with flocculation and photocatalysis for efficiently controlling harmful cyanobacterial blooms

Cyanophage Engineering for Algal Blooms Control

Mitigation of Cyanobacterial Harmful Algal Blooms by Electrochemical Ozonation: From Bench-scale Studies to Field Applications

Design, synthesis, high algicidal potency, and putative mode of action of new 2-cyclopropyl-4-aminopyrimidine hydrazones

Isolation and Identification of Two Algae-Lysing Bacteria against Microcystis aeruginosa

Biological and Chemical Approaches for Controlling Harmful Microcystis Blooms