Abstract:Tribological properties of polymer materials are traditionally tested on small-scale test rigs because of cost-efficiency and flexibility. For highly loaded applications (e.g., sea lock doors, retaining walls, positioning systems) however, large-scale tests should be performed for estimating the frictional behaviour and wear lifetime of different engineering polymers more accurately under nearly working conditions. In present paper, two filled polymer grades covering a broad range of mechanical properties polyethylene terephtalate (PET)/teflon (PTFE) and ultra high molecular weight polyethylene (UHMWPE)/carbon are slid against high alloy steel, stainless steel and epoxy resin, in order to make a selection for its use as bearing material under dry and lubricated conditions. A general thermal model is evaluated for present test rig. The coefficients of friction on large-scale tests are lower than those obtained from small-scale testing. Polymer wear rates are calculated from weight loss and compared to dimensional measurements (thickness reduction) including elastic deformation, thermal expansion and creep.Microscopic observation of the worn surfaces shows different wear mechanisms of PET/PTFE after sliding against stainless steel, developing a transfer layer onto the polymer surface, and after sliding against high alloy steel, causing polymer transfer onto the steel surface. The better adherence of a polymer transfer film onto a steel counterface is explained by higher attractive forces resulting from its high surface energy, while there is little adherence on stainless steel counterfaces in accordance with its lower surface energy and lower friction. Wear of PET/PTFE after sliding against stainless steel is partly caused by the incorporation of steel particles. After sliding of UHMWPE/carbon, no wear debris was observed as its higher toughness allows for tearing of the surface without particle detachment. The high surface toughness and abscence of a transfer film results however in higher friction.

Semi-analytical calculation model for friction of polymers on the example of POM ∣ PE-UHMW and steel ∣ PE-UHMW

A Friction Evaluation Method Based on Barrel Compression Test

Anomalous Lubrication Behavior of Metal-Polymer Tribo-Pairs

Molecular dynamics study on friction of polymer material polyoxymethylene (POM)

Experimental Analysis and Wear Prediction Model for Unfilled Polymer–Polymer Sliding Contacts

Triboanalysis of Antifrictional Materials Based on Polyamides for Metal-Polymer Sliding Bearings

A wear particle-based model of friction in a polymer–metal high pressure contact

A Pin-on-Disk Study of the Tribological Properties of Polyoxymethylene (POM) Gear Materials

Efficiency of Antifriction Solid Lubricant Coatings for Metal–Polymer Friction Pairs

Wear and the Transition from Static to Mixed Lubricated Friction of Sorption or Spreading Dominated Metal-Thermoplastic Contacts

Using mixture design approach for modeling and optimizing tribology properties of PPESK composites

On the ability of polymers to self-lubrication in metal – polymer friction pairs

Tribological Analysis of Engineering Plastics/Steel Friction Pairs

Integration of machine learning prediction and optimization for determination of the coefficient of friction of textured UHMWPE surfaces

Static friction of normal and reversed metal–polymer sliding pairs

A novel friction model for steel‐polymer interfaces in sliding seismic isolation bearings

Large-scale tests on friction and wear of engineering polymers for material selection in highly loaded sliding systems

Physico-mechanical, thermal, and tribological studies of polytetrafluoroethylene-filled polyoxymethylene/silicone composites

An Analytical Model of Mechanistic Wear of Polymers

A Computational Model for Analysing the Dry Rolling/Sliding Wear Behaviour of Polymer Gears Made of POM