Boosting the photothermal conversion efficiency of MXene film by porous wood for Light-driven soft actuators
Daotong Zhang,Kai Yang,Xinyi Liu,Min Luo,Zhao Li,Chaozheng Liu,Min Li,Weimin Chen,Xiaoyan Zhou
DOI: https://doi.org/10.1016/j.cej.2022.138013
IF: 15.1
2022-07-22
Chemical Engineering Journal
Abstract:Ti 3 C 2 T x (a typical MXene) has been widely used in light-driven actuators due to its outstanding photothermal conversion capability. However, the response speed of these actuators is always slow because the effective irradiated area is limited to their surface. Herein, we propose a wood-based composite material which is made by coating Ti 3 C 2 T x on delignified wood (DW). The high porosity of DW leads to high loading of Ti 3 C 2 T x and provides large irradiated areas, thus enhancing photothermal conversion efficiency. The delignification on wood can expose cellulose with highly hydrophilic surface for rapid diffusion of Ti 3 C 2 T x suspension, and the hydroxy in cellulose can act as binding sites to form stable combination with Ti 3 C 2 T x . Taking advantage of the good compressibility of DW, a simple densification is conducted on TDW (Ti 3 C 2 T x /DW) to greatly shorten the distance between adjacent oxygen-enriched Ti 3 C 2 T x nanosheets, enhancing the conjugation among nanosheets, thus endowing TDW with good flexibility and high heat transfer efficiency. Moreover, we manufacture a light-driven bilayer actuator comprised of TDW as the passive layer and low-density polyethylene (LDPE) as the active layer. Our light-driven actuator exhibits a tremendous angle variation of 160° at a light intensity of 120 mW/cm 2 . A series of devices based on the TDW/LDPE actuator are demonstrated, including simulated gestures, a four-finger soft gripper, and a bionic flower. Moreover, we propose a light-controlled smart switch which can be used on non-contact (COVID-19) or dangerous (blasting) occasions. Additionally, we present a finite element simulation to predict the bending deformation, which guides the accurate control of the devices.
engineering, chemical, environmental