Abstract:The stable operation of power transformers depends on the oil-paper insulation system, in which the aging degree of insulating paper is the key to evaluate the remaining life of the transformer. Currently, methanol extraction is widely used to detect the furfural content in oil to evaluate the aging state of insulating paper, but it ignores the influence of methanol produced during the operation of the transformer on the extraction results. To address this issue, this paper proposes a new method that can replace methanol extraction for detecting furfural in oil through simulation and experiment. Firstly, through simulation and experiment, it is proved that the strong vibration absorption peaks at 1677 cm-1 for furfural carbonyl and 2240 cm-1 for acetonitrile cyano can be used to establish a new method for extracting furfural content in oil using acetonitrile. A quantitative model between the concentration x of furfural in the furfural-acetonitrile mixed solution and the area y of the infrared absorption peak at 1677 cm-1 is established, with a goodness of fit of 0.9974. Secondly, a comparison between direct detection and acetonitrile extraction methods is conducted. The results show that direct detection is simple to operate, but the minimum detection concentration is 40mg/L, which is difficult to meet practical requirements. Acetonitrile extraction can reduce the minimum detection concentration to 0.1mg/L. At the same time, the extraction conditions are analyzed to determine the extraction ratio of 30, extraction times of 5, and extraction rate of 60%. Finally, the proposed detection method is applied to thermal aging tests on insulating paper of different types. The experimental results show that the proposed method has good repeatability and improves the detection resolution of furfural content. This paper combines infrared spectroscopy with acetonitrile extraction technology to open up a more efficient and practical new method for detecting furfural content in transformer oil.

Colorimetric Detection of Furfural with Enhanced Visible Absorption of Furfural-DNPH in Basic Conditions

Furfural Determination with Disposable Polymer Films and Smartphone-Based Colorimetry for Beer Freshness Assessment

A fluorescence-enhanced method specific for furfural determination in Chinese Baijiu based on luminescent carbon dots and direct surface reaction

Pipette-tip kapok fiber-based solid-phase extraction/in-situ derivatization for the rapid and green analysis of furfural compounds

A ratiometric fluorescence sensor for 5-hydroxymethylfurfural detection based on strand displacement reaction

Current sample preparation strategies for the chromatographic and mass spectrometric determination of furfural compounds

N, P-co-doped carbon dots as a dual-mode colorimetric/ratiometric fluorescent sensor for formaldehyde and cell imaging via an aminal reaction-induced aggregation process

Replacing liquid chromatography with tailored ion chromatography: A green method for detecting furfuryl alcohol and understanding its properties

Separation and Identification of Furanic Compounds in Fruit Juices and Drinks by High-Performance Liquid Chromatography Photodiode Array Detection

Understanding the Health Implications of Furan and Its Derivatives in Thermally Processed Foods: Occurrence, Toxicology, and Mixture Analysis

An Optical Device Based on a Chemical Chip and Surface Plasmon Platform for 2-Furaldehyde Detection in Insulating Oil

A Fluorescent Probe for Distinguish Detection of Formaldehyde and Acetaldehyde

A colorimetric probe for rapid and simultaneous detection of alkylresorcinols and ferulic acid based on in-situ coupling reaction in aqueous media

Colorimetric detection of furin based on enhanced catalytic activity of G-quadruplex/hemin DNAzyme

Furfural Wastewater Decolorization with Activated Carbon Prepared by Furfural Residues

Functionalized MXene (Ti3C2TX) Loaded with Ag Nanoparticles as a Raman Scattering Substrate for Rapid Furfural Detection in Baijiu

Molecularly Imprinted Chemiresistive Sensor for Specific Recognition of Furaneol as a Biomarker of Strawberry Flavor Conditions

A "naked eye" and ratiometric fluorescent chemosensor for rapid detection of F - based on combination of desilylation reaction and excited-state proton transfer

Responsive Photonic Hydrogel for Colorimetric Detection of Formaldehyde

Upconversion-based Intelligent Dual-Mode Hydrogel Nanosensor for Visual Quantitative Detection of Formaldehyde

Research on infrared spectroscopy detection of furfural content in transformer oil based on acetonitrile extraction