Abstract:Metallic glasses are frequently used as structural materials. Therefore, it is important to develop methods to predict their mechanical response as a function of the microstructure prior to loading. We develop a coarse-grained spring network model, which describes the mechanical response of metallic glasses using an equivalent series network of springs, which can break and re-form to mimic atomic rearrangements during deformation. To validate the model, we perform simulations of quasistatic, uniaxial tension of Lennard-Jones and embedded atom method (EAM) potentials for Cu$_{50}$Zr$_{50}$ metallic glasses. We consider samples prepared using a wide range of cooling rates and with different amounts of crystalline order. We show that both the Lennard-Jones and EAM models possess qualitatively similar stress $\sigma$ versus strain $\gamma$ curves. By specifying five parameters in the spring network model (ultimate strength, strain at ultimate strength, slopes of $\sigma(\gamma)$ at $\gamma=0$ and at large strain, and strain at fracture where $\sigma=0$), we can accurately describe the form of the stress-strain curves during uniaxial tension for the computational studies of Cu$_{50}$Zr$_{50}$, as well as recent experimental studies of several Zr-based metallic glasses. For the computational studies of Cu$_{50}$Zr$_{50}$, we find that the yield strain distribution is shifted to larger strains for slowly cooled glasses compared to rapidly cooled glasses. In addition, the average number of new springs and their rate of formation decreases with decreasing cooling rate. These effects offset each other at large strains, causing the stress-strain curve to become independent of the sample preparation protocol in this regime. In future studies, we will extract the parameters that define the spring network model directly from atomic rearrangements that occur during uniaxial deformation.

Low-speed orthogonal cutting of large Zr-based metallic glasses: A shear angle model considering internal friction and serrated chip formation

Prediction and Verification Analysis of Grinding Force in the Single Grain Grinding Process of Fused Silica Glass

Simulation of Chip Formation in High-Speed Hard Machining

Investigations into the effect of cutting speed on nano-cutting of metallic glass by using molecular dynamics simulation analysis

Understanding The Deformation Of Metals In High Speed Cutting

Coupled Thermo-mechanical Model for Metal Orthogonal Cutting Process and Finite Element Simulation

Serrated chip characteristics and formation mechanism in high-speed machining of selective laser melted Ti6Al4V alloys

Research on chip formation parameters of aluminum alloy 6061-T6 based on high-speed orthogonal cutting model

Effect of cutting conditions on the serrated chip formation in high-speed cutting

Research progress on cutting machining simulation technology of metallic glasses

Serration Behavior of A Zr-Based Metallic Glass under Different Constrained Loading Conditions

Investigation into Nanoscratching Mechanical Performance of Metallic Glass Multilayers with Improved Nano-Tribological Properties

Numerical and Experimental Investigation of the Shear Angle in High-Speed Cutting of Al6061-T6

Shear Transformation Zones and Serrated Flow Dynamics of Metallic Glasses Revealed by Nanoindentation

Analytical modelling of side grinding of orthogonal laminated SiCf/SiC composites based on effective elastic properties

Model for Predicting the Micro-Grinding Force of K9 Glass Based on Material Removal Mechanisms

Research on three-dimensional cutting force theoretical model of turning glass–ceramics based on discretization of cutting edge

Analytical modelling of edge chipping in scratch of soda-lime glass considering strain-rate hardening effect

Characterizing the mechanical response of metallic glasses to uniaxial tension using a spring network model

Nanocutting mechanisms of Cu50Zr50 amorphous alloy: A molecular dynamics simulation

Size Dependent Hidden Serration Behaviors of Shear Banding in Metallic Glass Thin Films