Abstract:The behavior of Dicumyl peroxide (DCP) under runaway conditions was studied using low and high phi factor (φ) calorimeters. Solutions of 20, 30 and 40%, by weight, of DCP in 2,2,4-trimethyl-1,3-pentanediol diisobutyrate and cumene were run at different phi factors experiments(1.8>φ>1.1). The results depicted that cumene reduces the severity of the runaway decomposition of DCP, while the phi factor of the experiments showed to have a high influence on the rise of temperature and pressure. Values up to 18 and 27 times higher, respectively, were obtained at same concentration when reducing the phi factor from 1.8 to 1.1. Temperatures and self-heating rates obtained at different phi factor experiments were scaled up to a phi factor equal to 1.0 using the correction method recommended by the Design Institute for Emergency Relief System (DIERS) and developed by Fisher [1]. The results showed that this method works well at low concentrations. However, at the highest concentration, fast heating rates (up to 600°C/min) were observed in the low phi factor equipment. These fast heating rates, most probably caused the equipment to loss its adiabaticity, and the scale up of the temperatures and self-heating rates did not longer give reliable results. This means that the estimation of experimental variables such temperature and rate of temperature rise (used for vent sizing calculations), directly from the data obtained at lab scale, even when using an advance low phi factor equipment, can result in under-conservative design calculations.

Evaluation of adiabatic runaway reaction and vent sizing for emergency relief from DSC

Runaway reaction investigation of di-tert-butyl peroxide using adiabatic calorimetry

Assessing an Experimental Approach for Chemical Explosive Mode and Heat Release Rate Using DNS Data

Runaway reaction and thermal hazards simulation of cumene hydroperoxide by DSC

Evaluation of adiabatic runaway reaction of methyl ethyl ketone peroxide by DSC and VSP2

Experimental sensitivity analysis of the runaway severity of Dicumyl peroxide decomposition using adiabatic calorimetry

Calculation of vent sizing for emergency relief system with modified DIERS method: an analysis of thermal decomposition runaway of cumene hydroperoxide system

Thermal hazard evaluation of sodium dichloroisocyanurate via TG-MS, DSC, and ARC

Thermal Runaway Criterion for Chemical Reaction Systems: A Modified Divergence Method

Investigative calorimetric studies and kinetic parameters estimation using analytical methods for self-reactive hazardous chemicals in a chemical manufacturing plant

Predicting Thermal Runaway in Styrene Polymerization Reactions: Divergence Criterion with Phase Space Reconstruction

Risk evaluation on the basis of pressure rate measured by automatic pressure tracking adiabatic calorimeter

Runaway decomposition of dicumyl peroxide by open cell adiabatic testing at different initial conditions

Modeling thermal analysis for predicting thermal hazards relevant to transportation safety and runaway reaction for 2,2′-azobis(isobutyronitrile)

Numerical Simulation of the Thermal Inertia of an Adiabatic Reaction Calorimeter in Reaction Thermal Safety Process

Safety relief analysis for methanol-acetic anhydride system by stationary methods and dynamic simulation

Thermal Research on the Uncontrolled Behavior of Styrene Bulk Polymerization

Parametric sensitivity and thermal runaway critical parameters in non-adiabatic fixed bed reactors

Consequence Analysis of Derivative Accidents Due to Reaction Runaway

Thermal Risk Assessment of the Complex Nitration Process Through Safety Operating Space Analysis and Optimization

Calorimetric studies and lessons on fires and explosions of a chemical plant producing CHP and DCPO