Abstract:Most nuclear power plants (NPPs) are looking deploying digital instrumentation and control (I&C) systems, which allow for more precise control and more economical operation. However, both the quantity and capability of industrial control system (ICS)-targeted cyber-attacks have grown dramatically over recent years. Therefore, one of the most significant challenges that digital I&C systems bring is the issue of cybersecurity, which should be enhanced before their deployment.Several different types of cyber-attacks can be introduced to NPPs; a false data injection attack on key equipment is the focus of this research due to the potential severe consequences associated with such an attack. In false data injection, the attackers may alter the reading of control sensors or commands to change the operation of an NPP. Current cybersecurity efforts focus on intrusion prevention by firewalls or data-flow direction control and use commercial intrusion detection systems, which usually focus on monitoring Internet Protocol (IP) addresses, ports, and payload length. However, attention should be given to conditions where these approaches can fail, such as an insider attack. Previous research based on process data shows the potential of a last defenseâ, line using online monitoring of the process data in concern with cyber data analysis. However, existing models involve different subsystems across the whole NPP, which has a wide attack surface and may require high computing cost. This holistic approach may not meet the time-sensitive requirements imposed upon I&C systems. This paper proposes a localized kit for key equipment in a process as a complementary detection method to improve the robustness of key equipment under cyber-attacks. Compared to existing models, this reduces the number of variables used in the model and significantly improves the computational speed. It also reduces the attack surface by limiting the data acquisition locally. This localized kit includes a cyber-attack detection model to detect anomalies within key components, such as the control system actuator, and an inference model to potentially reconstruct a compromised signal to allow the safe shut down.To develop and demonstrate the localized cybersecurity kit, a hardware-in-the-loop (HIL) testbed was built with a pressurized water reactor (PWR) simulator and a programmable logical controller (PLC). The PLC was programmed to control the steam generator (SG) water level at a specified set point, and the PWR simulator was utilized to simulate the nuclear system and response for parameters outside of the SG. Three false data injection attacks were conducted towards the testbed to generate the data needed for the localized kit development and evaluation. The results show the cyber-attack detection model is effective under false data injection scenarios and the inference model is promising as a signal reconstruction method.

Fishy Cyber Attack Detection in Industrial Control Systems

Network Security Situation Awareness for Industrial Control System under Integrity Attacks

State Machine Based Malicious Packet Attack Detection and Security Situation Assessment

An Improved Support Vector Machine Attack Detection Algorithm for Industry Controls System

A Machine Learning Based Framework for Real-Time Detection and Mitigation of Sensor False Data Injection Cyber-Physical Attacks in Industrial Control Systems

A Deep Multi-Modal Cyber-Attack Detection in Industrial Control Systems

Intrusion Detection and Localization for Networked Embedded Control Systems

Investigation of Cyber Attacks on a Water Distribution System

Robust localized cyber-attack detection for key equipment in nuclear power plants

An Active Detection Strategy Based on Dimensionality Reduction for False Data Injection Attacks in Cyber-Physical Systems

Cyber Attack Detection of I&C Systems in NPPS Based on Physical Process Data

Implementation and Detection of Novel Attacks to the PLC Memory of a Clean Water Supply System

Assessment of Cyber-Physical Intrusion Detection and Classification for Industrial Control Systems

Detecting Cyberattacks in Industrial Control Systems Using Online Learning Algorithms

A data‐driven safety preserving control architecture for constrained cyber‐physical systems

Anomaly detection using isomorphic analysis for false data injection attacks in industrial control systems

False Data Injection Attack Detection, Isolation, and Identification in Industrial Control Systems Based on Machine Learning: Application in Load Frequency Control

An Analytics Framework for Heuristic Inference Attacks against Industrial Control Systems

A Data-Driven Safety Preserving Control Architecture for Constrained Cyber-Physical Systems

Control Behavior Integrity for Distributed Cyber-Physical Systems

Wavy-attention network for real-time cyber-attack detection in a small modular pressurized water reactor digital control system