A facile one-step jet-milling approach for the preparation of proliposomal dry powder for inhalation as effective delivery system for anti-TB therapeutics
Teerapol Srichana,Fredrick Nwude Eze,Ekawat Thawithong
DOI: https://doi.org/10.1080/03639045.2022.2135101
IF: 3.727
2022-10-28
Drug Development and Industrial Pharmacy
Abstract:Physicochemical characterization and assessment of aerosol dispersion performance of anti-TB proliposome dry powders for inhalation (DPIs) prepared using a single-step jet-milling (JM) approach. Conventional tuberculosis (TB) treatment involves isoniazid and rifampicin as first-line agents in extended oral multi-drug regimes. Liposomal DPIs are emerging as promising alternatives for targeted delivery of anti-TB agents to alveolar macrophages harboring Mycobacterium tuberculosis . However, traditional approaches for liposomal DPI preparation are tedious, time consuming and require sophisticated/expensive equipment. The proposed JM technique for preparation of proliposome DPIs could obviate these limitations and facilitate use of these drugs for more effective and safer treatment. Proliposome DPIs containing isoniazid and/or rifampicin, cholesterol and cholesterol sulfate were successfully prepared via JM (injection pressure, 7.4 bar; milling pressure, 3.68 bar). Their physicochemical, content uniformity, and in vitro aerosol dispersion performance were assessed using scanning electron microscopy/energy-dispersive X-ray spectroscopy, transmission electron microscopy, dynamic light scattering/Zeta potential, X-ray diffraction spectroscopy, thermogravimetric analysis, high-performance liquid chromatography, and the Next-Generation Impactor. The DPIs exhibited consistent, spherically shaped, smooth particles. Drug particles were evenly distributed with acceptable content uniformity. Drug crystallinity was not significantly affected by milling and the formulations had minimal (<2.0%) water content. After reconstitution of the DPIs, the hydrodynamic size was about 370.9–556.2 nm and charge was –12.3 to –47.3 mV. Furthermore, the proliposome DPIs presented emitted dose (69.04–89.03%), fine particle fraction, <4.4 μm (13.7 − 57.8%), and mass median aerodynamic diameter (<3.0 μm), which satisfied the requirements for deep lung delivery. The proposed approach was suitable for preparation of proliposome DPIs that could be deployed for local targeting of the lower respiratory tract for the treatment of TB.
pharmacology & pharmacy,chemistry, medicinal